F.S. Magnaflows to fit M coupe/rdstr [Archive] - Bimmerfest - BMW Forums

: F.S. Magnaflows to fit M coupe/rdstr

Bob Clevenger
06-21-2005, 06:52 PM
Sold to BOL.

I have a set of Magnaflow mufflers with hangers and pipe welded on to fit my '02 M coupe.
Just cut off the exhaust pipe in front of the mufflers (measure first!) and weld on a 2-1/4" three-bolt flange (check that it mates up with the one on the pipe first) and bolt them on. Any decent muffler shop should be able to do this easily. Oh, they do require about 3/8" to be trimmed from the rear bumber on the inside of the tailpipe cutouts to clear the 3" tips.

These already have 9" resonators welded in place. Even with the resonators, they are just too loud for my taste. Nice, but loud. They are about two months old.

The original install was done by Mesa Muffler in Costa Mesa, CA and cost me about $600; I had the resonators added at Central Muffler in Chino, CA and they set me back another $100 or so (I don't recall exactly). I'll sell them for $350

Sold to BOL

06-21-2005, 09:54 PM
you have me sold

email me!

Bob Clevenger
06-21-2005, 10:55 PM
you have me sold

email me!

Send me your e-mail address and I will.
Your profile doesn't allow e-mailing you.

Oops, I just checked my PMs --- BOL got there before you.