PDA

View Full Version : Air Supply Device Temp Sensor specs?


rat runner
11-08-2007, 07:55 PM
Hi. First post on this forum. The service center says my Suspension Air Supply Device (compessor) Temp Sensor is "open circuit" and I need a new pump assembly@ $1000. I measured it right at the connector (green wires)and its not open but about 8 K ohms at 10 degrees C. It comes down in resistance when you put a little heat to the compressor head. Does anyone know the resistance spec for the sensor or would like to speculate on my SELFLEVEL SUSP INAC problem. Thanks.