PDA

View Full Version : ABS/TCS after brake wear sensor replacement


andyt
07-16-2012, 06:43 PM
Grrrr.... I replaced the rear brake wear sensor and now I'm getting ABS/TCS and Flat tire warnings. I haven't done it yet, but I'm going to reset the tire preasure sensor. All previous posts point to the ABS controller, but I can't believe that's my issue since it worked fine. The mistake I made was pulling the plug on the ABS instead of the ware sensor. Is there/what is the procedure for resetting the ABS/TCS warnings? BTW, I get zero enjoyment out of working on this car....:mad:

andyt
07-16-2012, 08:59 PM
Just annoying.... I reset the tire preasure sensor. That didn't do anytyhing. So I tried disconnected the neg side of the battery hoping to reset the computer. Nope.... Now I have (4) codes, now the Active Steering warning is on too. Great.... It's going to throughly piss me off if I have to take this to a shop to get these codes reset. :mad::mad::mad: