Need real quick help re: driveshaft install

[Tangent]

I just got back with a rebuilt driveshaft and am about to install it when I noticed I didn't make a note of how exactly is was bolted to the tranny. I've got the front of the driveshaft with it's 3 flanges, the guibo with it's 6 bolt holes, the vibration damper with it's 3 holes and cut outs to allow for the other 3, and then of course the 3 flanges on the trannny output shaft. What gets bolted to what exactly? Do I bolt the guibo and the vibration damper to the driveshaft and then just have bolts go through the guibo into the tranny output flange? Or do I bolt the guibo to the driveshaft and then slide the vibration damper over that and bolt the guibo to the damper and the output flange? Am I even making sense? :confused:

[99flhr]

Perhaps viewing the parts breakdown at realoem.com would help.

[Tangent]

Lol, thanks for the reply. The driveshaft's been installed for nearly a month already but it's the thought that counts. :p

[99flhr]

Lol, thanks for the reply. The driveshaft's been installed for nearly a month already but it's the thought that counts. :p

Guilty as charged, paid no attention to the date untill it was too late. Was trying to install (without sucess) those parts/service CD`s from E-bay and had my head in a very dark place. Sorry. Mea culpa. :tsk:

[sgarcia89lx]

i know im awaking this thread from the dead but im replacing the center bearing and need help from some who's done this before .i've loosened everything and i still can seem to take this shaft out is there somthing i'm missing. :mad: :mad: every nut bolt is off nothing holding it but i cant seem to get it out seems like the rear end housing is in the way. :dunno:

[sgarcia89lx]

never mind i took it out:rolleyes: