Welcome to Bimmerfest -- The #1 Online Community for BMW related information! Please enjoy the discussion forums below and share your experiences with the 200,000 current, new and past BMW owners. The forums are broken out by car model and into other special interest sections such as BMW European Delivery and a special forum to voice your questions to the many BMW dealers on the site to assist our members!
Please follow the links below to help get you started!
Sorry for the delay, but I have been out of the country. The valve cover job itself, is very labor intensive. Following the instructions on TIS helps, but there is a lot of info that is left out between the lines. Having the proper torx tools, flex couplings, & impact tools helps a lot. Removing the cowl are components is the key to the job. Remove the charcoal canisters with the attached cowl coverings on both sides. Then you must remove the center section partition wall. You will probably think you don't need to remove it, but removal is a must. You will not get the valve covers off without damaging the Eccentric Shaft Sensors. At 400 a pop, you will under stand why! Replace all gaskets & o-rings, & sensor gaskets on the valve covers is a must. Expect 4 to 10 hours a side, based on your luck & skills. I have a bunch of pics, I just not had the time to do a DIY. I will be glad to help where possible, if you need some guidance.
Hey, how's going?
I'm about to attempt a valve cover gaskets replacement. Talked to Yorgi and he suggested writing you a PM. Could you please advice on some issues that you have encounter during this job? Do you have any pics or literature on the DIY or any advice in general? I know it's a very labor-intensive job, but is it pure mechanical, i.e.: take it apart and put it back together?