Bimmerfest - BMW Forums - View Profile: HerbP

Welcome to Bimmerfest -- The #1 Online Community for BMW related information! Please enjoy the discussion forums below and share your experiences with the 200,000 current, new and past BMW owners. The forums are broken out by car model and into other special interest sections such as BMW European Delivery and a special forum to voice your questions to the many BMW dealers on the site to assist our members!

Please follow the links below to help get you started!

Go Back   Bimmerfest - BMW Forums > Members List

HerbP HerbP is offline

Officially Welcomed to the 'Fest

Visitor Messages

Showing Visitor Messages 1 to 3 of 3
  1. Mulchman
    02-23-2017 08:16 PM
    SWEET!!!! I knew you had it

    My experience with the TB rebuild sounds very similar to yours. I know you can turn a wrench and not much scares you, so the rest is just doing it for the first time. All of these sucky jobs are easy the second time and now look at you driving your 7 like you own the road again! Hahaha Very cool message at the end of a long day. Thanks for sharing! What would we do without the 'fest?
  2. HerbP
    10-27-2011 04:15 PM
    Sorry for the delay, but I have been out of the country. The valve cover job itself, is very labor intensive. Following the instructions on TIS helps, but there is a lot of info that is left out between the lines. Having the proper torx tools, flex couplings, & impact tools helps a lot. Removing the cowl are components is the key to the job. Remove the charcoal canisters with the attached cowl coverings on both sides. Then you must remove the center section partition wall. You will probably think you don't need to remove it, but removal is a must. You will not get the valve covers off without damaging the Eccentric Shaft Sensors. At 400 a pop, you will under stand why! Replace all gaskets & o-rings, & sensor gaskets on the valve covers is a must. Expect 4 to 10 hours a side, based on your luck & skills. I have a bunch of pics, I just not had the time to do a DIY. I will be glad to help where possible, if you need some guidance.

  3. petros2r
    10-20-2011 10:17 AM
    Hey, how's going?
    I'm about to attempt a valve cover gaskets replacement. Talked to Yorgi and he suggested writing you a PM. Could you please advice on some issues that you have encounter during this job? Do you have any pics or literature on the DIY or any advice in general? I know it's a very labor-intensive job, but is it pure mechanical, i.e.: take it apart and put it back together?
    Many thanks!

About Me

  • About HerbP
    What I drive
    2005 645Ci & 2007 750Li


Total Posts
Visitor Messages
General Information
  • Last Activity: Yesterday 09:32 PM
  • Join Date: 07-05-2009
  • Referrals: 0


Showing Friends 1 to 8 of 8

All times are GMT -7. The time now is 01:54 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
© 2001- VerticalScope Inc. All rights reserved.