Bimmerfest - BMW Forums

Bimmerfest - BMW Forums (http://www.bimmerfest.com/forums/index.php)
-   E36 (1991 - 1999) (http://www.bimmerfest.com/forums/forumdisplay.php?f=97)
-   -   Bleeding air out of the radiator? (http://www.bimmerfest.com/forums/showthread.php?t=103490)

Charliewww 07-02-2005 09:03 PM

Bleeding air out of the radiator?
 
I have a 94 325i. The thermostat went out and I replaces it. It is still overheating and I get no heat to come out the heater. Im am trying to bleed the air out of the radiator but must not be doing it correctly. I removed the resivor cap and bleed screw filled the resivor untill the bubbles stopped coming out of the bleeder. I put the bleed screw back in, turned the heat full blast, started the car and let it run until it went past the 3/4 mark and shut the engine down before it hit the red. Let it cool check the resivor and started it again. It does the same thing over and over again and still no heat. Should I actually take it for a drive? Or am I missing a step of the bleeding?

Thanks for you Help!

Charliewww 07-03-2005 12:20 AM

Update. Again I started the car, let it warm up and had the bleed screw cracked. It hissed and hissed for over 5 minutes and I tightened it. Should I keep going or will it just keep hissing? How long could this take?

Charliewww 07-03-2005 10:22 PM

Fixed it water pump was shot


All times are GMT -7. The time now is 03:20 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
© 2001-2011 performanceIX, Inc. All Rights Reserved .: guidelines .:. privacy .:. terms