Bimmerfest - BMW Forums

Bimmerfest - BMW Forums (http://www.bimmerfest.com/forums/index.php)
-   E60 M5 (2006 - 2010) (http://www.bimmerfest.com/forums/forumdisplay.php?f=110)
-   -   Misfiring of Cylinder No. 6 (http://www.bimmerfest.com/forums/showthread.php?t=619711)

sam joe 05-08-2012 03:29 PM

Misfiring of Cylinder No. 6
 
Hello guys

I have a strange problem with my M5 - where it recently giving me an reduced power message where the RPM redline goes all the way into the 4.5 & the car losses power big time and start rattling.

My problem it sometime it does this and sometimes it works fine, but mostly of the time it is giving me a reduced power message.

On the computer it showing misfiring on cylinder 6 -- all the time, when the reduce engine appear misfiring on cylinder 6 error comes up on the computer.

I replaced the plugs, and change the coils, cleaned and changed couple of the injectors but the same problems is still happening

Any advise

Sam

hmouradian10 05-24-2012 01:41 AM

i have this same problem when i step on it on the freeway i get ''engine malfunction reduced power'' ....it says cylinder 3 misfire everytime..i put new plugs i swapped coils and injectors still same problem with cylinder 3 anyone have this problem resolved?

suprlude 09-19-2012 04:10 PM

Ionic control sensor is your problem! I has the same issue with my e60 m5 and did everything you did until i found out about the ionic control sensor. There are two, swap out the left bank to the right bank one and your error code will now read cylinder 10 misfire, if so you know for a fact the ionic control sensor has gone bad, hope this helps you and saves you some $!

azziat 12-10-2013 05:06 PM

cyl 4 missfire
 
i have this issue right now
is anyone knows what is the problem?
swaped spark plugs, coils, ionic module injectors still misfire on 4

suprlude 12-11-2013 06:51 AM

its 100% the ionic sensor, its located right on the front bank, swap the left and right bank and your cel code should change to cylinder 10, then youll know its the sensor.

Baramack 05-16-2014 07:07 AM

Hey guys i got misfire on cylinder 6-10. Any advice before replacing all coils and plugs? Will try switching ionic control sensor


Sent from BimmerApp mobile app


All times are GMT -7. The time now is 10:23 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
© 2001-2011 performanceIX, Inc. All Rights Reserved .: guidelines .:. privacy .:. terms