Bimmerfest - BMW Forums

Bimmerfest - BMW Forums (http://www.bimmerfest.com/forums/index.php)
-   7 Series - E38 (1995 - 2001) (http://www.bimmerfest.com/forums/forumdisplay.php?f=156)
-   -   Just replaced my cps now wont start (http://www.bimmerfest.com/forums/showthread.php?t=629426)

1996bmw740il 06-25-2012 07:36 PM

Just replaced my cps now wont start
 
I just replaced my camshaft position sensor and. Cleaned my maf and now it wont start just keeps cranking? Any ideas? Maybe my maf is still wet from cleaning it will that cause it not to start?



Matt

Sent from my DROID RAZR using Bimmer App

joyism5 06-26-2012 12:25 AM

The car should start with the MAF unplugged too, so that's not the reason. I would compare one replacement with the one removed to see if they are identical (long enough). Are they OEM?

sinaiflash 12-31-2012 09:31 PM

The same thing just happened to me today. My check engine light has been on for 2 years, i scanned it back then and it said the right cps was bad. I got one from ******************.com it came without the o ring, today i changed it and the car just cranked but no start. I scanned it again and it said no codes. I finally put the old one back in and it fired right up. The one thing i noticed on the new cps is that the wires are molded to go to the rear and the oem one they went towards the front. It has to be that the replacement cps is not right.

Theonlybmw 09-21-2014 10:15 AM

I had the same problem I changed the old one put the new one on an it still did the same thing I scanned it again an it's still giving me the same code is there anyway to tell if the CPs the (new one ) is bad


All times are GMT -7. The time now is 07:47 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
© 2001-2011 performanceIX, Inc. All Rights Reserved .: guidelines .:. privacy .:. terms