135i on Professor MS3
 

Check out this 135i which belongs to John Zhang of 1013mm. He's running 18x9 and 18x10 Professor MS3. Gallery post here

http://www.ssr-wheels.com/gallery/im...35i_ms3_01.jpg
http://www.ssr-wheels.com/gallery/im...35i_ms3_02.jpg
http://www.ssr-wheels.com/gallery/im...35i_ms3_03.jpg

Nice stance but the deep dish and stretched look just doesn't do it for me.

Like the wheels, hate stance on performance oriented cars...

https://sphotos-b.xx.fbcdn.net/hphot...18596431_o.jpg
https://sphotos-a.xx.fbcdn.net/hphot...50447298_o.jpg

Meh - overkill look

For sure. It's just trying too hard to look good.

What SSRs are available in the proper offsets for the 1er?

The owner of this car was going for a particular look with an aggressive wheel fitment. For those of you that like a meaty tire there is a wide range of offsets for not just this wheel but all of our wheels. Here is the offset chart for this particular wheel in 18"

http://www.ssr-wheels.com/wheels/whe...=500&width=700

http://www.more-japan.com/blogs/wp-c...nch_offset.jpg

For the 1 Series, you can use SL Disk front and back since the overhang of the brakes compared to the rotor hat is minimal. The numbers in the grey box above the colored offset columns is the depth of the lip. Let us know if you have any other questions.