Hi, long time reader - first time poster :)
I am amazed by the knowledge and passion of everyone on here!
I am a long time 7 owner - had a '98 750iL and for the last several years '04 745Li - fabulous cars - but hard on the wallet!
The dealer tells me I have a bad steering angle sensor. I believe that is in the SZL "Switch unit steering column" which I believe I can get online for about $375 from Tomkinson.
I've ordered the BMW TIS, Dis, SSS software and interface to connect to my car. Will this allow me to code the SZL after replacement? Is it difficult to replace? I've searched for a DIY post and haven't found one.
Has anyone done it, or should I bite the bullet and have the dealership replace it?
You can actually try to fix yours.
Inpa will reset it.
|All times are GMT -7. The time now is 06:03 AM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
© 2001-2011 performanceIX, Inc. All Rights Reserved .: guidelines .:. privacy .:. terms