Bimmerfest - BMW Forums

Bimmerfest - BMW Forums (http://www.bimmerfest.com/forums/index.php)
-   7 Series - E65 / E66 (2002 - 2008) (http://www.bimmerfest.com/forums/forumdisplay.php?f=126)
-   -   Oil Pressure Sender (http://www.bimmerfest.com/forums/showthread.php?t=662751)

cmpcpro 12-07-2012 10:10 AM

Oil Pressure Sender
 
Hey guys, I have an oil leak on the pass side. and I am sure it's the vacuum pump needing to be replaced but that will have to wait a week or two, and it's not a bad leak.. but I would like to replace my oil pressure sender too as it may be leaking and I already have a brand new one.. I read somewhere on here someone used a deep 24? and an extension? I can't find it again, but do I have to remove the air box and or anything else to get to it?

Thanks!

mrbmwx5 12-07-2012 11:46 AM

http://tis.spaghetticoder.org/s/view.pl?1/07/45/86

745iguy 12-07-2012 02:55 PM

It was me, to remove the original Oil pressure switch, i used a deep socket 24 and an extension, whole air box (top an d bottom) prolly should move the MAF and elbow also.
the new switch i had fit the o2 sensor socket i had and an extension. its easy.

http://www.bimmerfest.com/forums/sho...86&postcount=1

cmpcpro 12-07-2012 07:03 PM

Thanks, when I did my angel eyes I tried to remove the air box I took out all the bolts, I checked all over, but I could not get it to actually come out. It moved pretty freely but no go.. I ended up putting them in with the box in, which everyone said couldn't be done... it can if you can handle alot of hand pain :)

745iguy 12-07-2012 07:14 PM

did u free the screws on the exp tank and move it over? u need to do that to remove the lower portion of the air filter box.


All times are GMT -7. The time now is 12:13 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
© 2001-2011 performanceIX, Inc. All Rights Reserved .: guidelines .:. privacy .:. terms