Welcome to Bimmerfest -- The #1 Online Community for BMW related information! Please enjoy the discussion forums below and share your experiences with the 200,000 current, new and past BMW owners. The forums are broken out by car model and into other special interest sections such as BMW European Delivery and a special forum to voice your questions to the many BMW dealers on the site to assist our members!

Please follow the links below to help get you started!

Go Back   Bimmerfest - BMW Forums > Search Forums

Showing results 1 to 25 of 35
Search took 0.36 seconds.
Search: Keyword(s): ; Posts Made By: Titansilber98M3
Forum: E36 M3 (1995-1999) 09-08-2013, 01:59 PM
Replies: 0
Views: 958
Posted By Titansilber98M3
Eibach Sway bar install issues?

I just bought eibach front 26mm and rear 24mm set of sway bars, the front had no issues at all but the rear came with new stock end links and they're making contact with the lower control arm in the...
Forum: E30 (1982 - 1993) 05-07-2013, 12:28 PM
Replies: 6
Views: 514
Posted By Titansilber98M3
Tachometer is going insane!

So I need to replace the Si batteries in the cluster?


Sent from BimmerApp mobile app
Forum: E30 (1982 - 1993) 04-19-2013, 05:25 PM
Replies: 6
Views: 514
Posted By Titansilber98M3
Tachometer is going insane!

Maybe my best bet IS a replacement cluster


Sent from BimmerApp mobile app
Forum: E30 (1982 - 1993) 04-19-2013, 05:23 PM
Replies: 6
Views: 514
Posted By Titansilber98M3
Tachometer is going insane!

I haven't replaced it, can't say about the PO but if that were the case I would think it would be sitting high at idle and it sits normal. Sometimes it's fine too it hits redline right where it...
Forum: E30 (1982 - 1993) 04-15-2013, 09:11 PM
Replies: 6
Views: 514
Posted By Titansilber98M3
Tachometer is going insane!

Hi all, I just purchased a 1989 325i sedan 5 speed just shy of 200k, and I noticed when I really step on it, the needle for the tachometer is very optimistic. It goes past the 7k mark to about where...
Forum: E36 M3 (1995-1999) 02-26-2013, 08:56 PM
Replies: 53
Views: 37,902
Posted By Titansilber98M3
Thanks those RC's look amazing, do you have any...

Thanks those RC's look amazing, do you have any rubbing if you run the 255's?
Forum: E36 M3 (1995-1999) 02-05-2013, 02:40 PM
Replies: 53
Views: 37,902
Posted By Titansilber98M3
Beautiful car. What size/offset are your wheels...

Beautiful car. What size/offset are your wheels and What tire sizes are you running?
Forum: E36 M3 (1995-1999) 01-11-2013, 09:37 PM
Replies: 2
Views: 928
Posted By Titansilber98M3
I agree I've had no drivability problems I just...

I agree I've had no drivability problems I just had no idea how noisy and grumbly it would sound, thanks!
Forum: E36 M3 (1995-1999) 01-04-2013, 09:49 PM
Replies: 2
Views: 928
Posted By Titansilber98M3
Rattling Noise From Transmission!!

Help! I recently replaced the clutch, flywheel, pressure plate, throw-out bearing, pilot bearing and shifter with an F1 stage 1 clutch and ltw flywheel kit on my 98 m3 coupe and now I have a rattling...
Forum: E36 M3 (1995-1999) 11-21-2012, 05:59 PM
Replies: 4
Views: 2,758
Posted By Titansilber98M3
I think I'll go with the f1 stage 1 clutch or...

I think I'll go with the f1 stage 1 clutch or Sachs oe, not sure which one yet, but I can't see spending twice the money if I don't need to.
Forum: E36 M3 (1995-1999) 11-16-2012, 10:35 PM
Replies: 4
Views: 2,758
Posted By Titansilber98M3
Hmm, what uuc clutch kit did you go with? How's...

Hmm, what uuc clutch kit did you go with? How's the flywheel? Do you think it's worth the extra $$$ over the eBay one?
Forum: E36 M3 (1995-1999) 11-14-2012, 11:12 PM
Replies: 4
Views: 2,758
Posted By Titansilber98M3
Alternatives to UUC flywheel and clutch?

I think its about time for a clutch and while im at it i'd like to replace the flywheel with a light weight one. UUC is about a 1000 and ive found some other kits on ebay with a SACHS oe clutch for...
Forum: E36 (1991 - 1999) 09-19-2012, 11:20 PM
Replies: 5
Views: 663
Posted By Titansilber98M3
Oh I did pass on it, but the owner tried putting...

Oh I did pass on it, but the owner tried putting blame on me and tried getting me to pay for it! It was just for my own curiosity cause I've never heard of this?
Forum: E36 (1991 - 1999) 09-19-2012, 06:42 PM
Replies: 5
Views: 663
Posted By Titansilber98M3
I was on a test drive I shifted into second in...

I was on a test drive I shifted into second in low revs ok but then as soon as I shifted about 5900 2nd gear just went? And then it wouldn't go at all
Forum: E36 (1991 - 1999) 09-19-2012, 01:58 AM
Replies: 5
Views: 663
Posted By Titansilber98M3
325is no 2nd gear?!

I was driving a 95 325is and when i shifted 1st to 2nd under power 2nd gear just wasnt there? the shifter locks as if it is in 2nd but the engine is floating as if its in neutral?? all other gears...
Forum: E36 M3 (1995-1999) 08-04-2012, 10:07 AM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
Ok vorshlag showed me exactly what needs to be...

Ok vorshlag showed me exactly what needs to be measured in an email. Do you have an email address so I can forward the message to you? I already ordered the coils just wanted to make sure with you...
Forum: E36 M3 (1995-1999) 07-23-2012, 10:26 PM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
Ok thanks a lot! I'll put in my order for some...

Ok thanks a lot! I'll put in my order for some FK's soon
Forum: E36 M3 (1995-1999) 07-22-2012, 12:40 AM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
And they also say the strut style matters as well...

And they also say the strut style matters as well there's an option for koni square and koni tapered I'm not sure how you would be able to tell that though
Forum: E36 M3 (1995-1999) 07-22-2012, 12:38 AM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
They say that the measurement is from the inside...

They say that the measurement is from the inside of the spring
Forum: E36 M3 (1995-1999) 07-17-2012, 09:56 PM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
Have any idea which Vorshlag plates fit I really...

Have any idea which Vorshlag plates fit I really wanna run with those on the fk's they show 2.25 in 2.5 in and 60mm I'm not sure where that measurement takes place though
Forum: E36 M3 (1995-1999) 07-13-2012, 10:23 PM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
Vorshlag gives the option for 2.25 in 2.5 in and...

Vorshlag gives the option for 2.25 in 2.5 in and 60mm for coilovers do you know which ones are compatible with the fk's? Or any other camber/caster plates that people run with the fk's?
Forum: E36 M3 (1995-1999) 07-12-2012, 10:49 PM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
ECS tuning what's the spring width of the FK's so...

ECS tuning what's the spring width of the FK's so i know what size camber plates to run.
Forum: E36 M3 (1995-1999) 05-19-2012, 03:01 PM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
No more than 1500 definitely, the less I have to...

No more than 1500 definitely, the less I have to spend the better. I'm trying to buy ASAP due to the insides off my front tires. That konigsport kit looks great but there doesn't seem to be any...
Forum: E36 M3 (1995-1999) 05-16-2012, 04:29 PM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
Alright I figured a big name would be the best...

Alright I figured a big name would be the best way to go just wondering if anyone had tried them. Any suggestions for being on a budget??
Forum: E36 M3 (1995-1999) 05-15-2012, 03:13 PM
Replies: 23
Views: 7,778
Posted By Titansilber98M3
Well I want a good drop and my car is over 100k...

Well I want a good drop and my car is over 100k so it's due for struts and shocks and also my front camber is off and since there's no adjustment I need to get camber plates. I also am planning a few...
Showing results 1 to 25 of 35

Forum Jump

All times are GMT -7. The time now is 03:09 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
© 2001-2011 performanceIX, Inc. All Rights Reserved .: guidelines .:. privacy .:. terms