Welcome to Bimmerfest -- The #1 Online Community for BMW related information! Please enjoy the discussion forums below and share your experiences with the 200,000 current, new and past BMW owners. The forums are broken out by car model and into other special interest sections such as BMW European Delivery and a special forum to voice your questions to the many BMW dealers on the site to assist our members!

Please follow the links below to help get you started!

Go Back   Bimmerfest - BMW Forums > Search Forums

Showing results 1 to 25 of 222
Search took 0.71 seconds.
Search: Keyword(s): ; Posts Made By: Podmore
Forum: 7 Series - E38 (1995 - 2001) 12-01-2016, 09:03 PM
Replies: 15
Views: 660
Posted By Podmore
You to make sure that the heater is turned to...

You to make sure that the heater is turned to full hot when bleeding the cooling system, and have the car parked with the front slightly raised. The lack of heat until you turn the defroster on is a...
Forum: 7 Series - E38 (1995 - 2001) 11-21-2016, 03:11 AM
Replies: 8
Views: 879
Posted By Podmore
There is a temperature sensor in the internal...

There is a temperature sensor in the internal wiring harness in the trans:
http://www.realoem.com/bmw/enUS/showparts?id=GG83-USA-11-1999-E38-BMW-740i&diagId=24_0725 Item 13. AFAIK this talks to the...
Forum: 7 Series - E38 (1995 - 2001) 11-04-2016, 10:19 PM
Replies: 6
Views: 429
Posted By Podmore
P0011 indicates that the timing on the inlet cam...

P0011 indicates that the timing on the inlet cam is too advanced. This could indicate that the Oil Control Valve solenoid (which controls the variable cam timing) is mechanically open at all times -...
Forum: 7 Series - E38 (1995 - 2001) 05-21-2016, 06:34 AM
Replies: 10
Views: 639
Posted By Podmore
Are you sure you have a MkII? I thought in a 2001...

Are you sure you have a MkII? I thought in a 2001 model you should have the MkIII.
Not that it probably makes much difference given what you are planning to do ...
Forum: 7 Series - E38 (1995 - 2001) 05-02-2016, 12:55 AM
Replies: 10
Views: 595
Posted By Podmore
Yup so first thing you need to do is charge the...

Yup so first thing you need to do is charge the car battery ... then report back if you still have problems!
Forum: 7 Series - E38 (1995 - 2001) 05-02-2016, 12:49 AM
Replies: 4
Views: 408
Posted By Podmore
AFAIK it's the mounting for the older style...

AFAIK it's the mounting for the older style cable-control cruise control units (before drive-by-wire). Obviously BMW had plenty of pre-made brackets and weren't going to throw them out just because...
Forum: 7 Series - E38 (1995 - 2001) 04-30-2016, 06:18 PM
Replies: 7
Views: 428
Posted By Podmore
I guess maybe if there's an opportunity to...

I guess maybe if there's an opportunity to educate the casual reader at the same time as suggesting a solution to the problem being posed, we should embrace it!! :thumbup:
Forum: 7 Series - E38 (1995 - 2001) 04-30-2016, 05:43 PM
Replies: 11
Views: 707
Posted By Podmore
Yup. Saves a lot of head-scratching when we don't...

Yup. Saves a lot of head-scratching when we don't have to guess .... like "Hey guys, my car won't start. What could be the problem?"
Forum: 7 Series - E38 (1995 - 2001) 04-29-2016, 12:50 AM
Replies: 2
Views: 330
Posted By Podmore
"The only thing I noticed" .... this is THE thing...

"The only thing I noticed" .... this is THE thing that will most likely be the problem. Possibly the thrust arm bushing has failed, which allows the wheel to move backwards under load and braking -...
Forum: 7 Series - E38 (1995 - 2001) 04-29-2016, 12:28 AM
Replies: 11
Views: 707
Posted By Podmore
Well the overheating is probably the best clue -...

Well the overheating is probably the best clue - combined with the moisture issue, it could be that you have either a cracked head or blown head gasket. A compression test will tell the tale quick...
Forum: 7 Series - E38 (1995 - 2001) 04-29-2016, 12:08 AM
Replies: 7
Views: 428
Posted By Podmore
The starter solenoid is essentially an...

The starter solenoid is essentially an electromagnetically operated piston which performs two functions: it drives the Bendix gear (which slides on a spiral shaft on the end of the starter shaft)...
Forum: 7 Series - E38 (1995 - 2001) 04-28-2016, 11:29 PM
Replies: 3
Views: 315
Posted By Podmore
Well I'm glad we have the automatic version here...

Well I'm glad we have the automatic version here in Oz too because over here we have drivers who are too stupid to even use their indicators, so fat chance they would manually adjust their headlight...
Forum: 7 Series - E38 (1995 - 2001) 04-27-2016, 10:52 PM
Replies: 18
Views: 1,207
Posted By Podmore
Possibly got water in one of the sensors causing...

Possibly got water in one of the sensors causing it to short out. The system will not operate correctly unless all sensors are active so hence the single beep. The PDC control is located behind the...
Forum: 7 Series - E38 (1995 - 2001) 04-27-2016, 10:45 PM
Replies: 18
Views: 1,207
Posted By Podmore
haha. If I Recall Correctly (IIRC), Park Distance...

haha. If I Recall Correctly (IIRC), Park Distance Control (PDC) and it's e38.org - however there are a few broken links there so a better site would be Timm's E38 site http://www.meeknet.co.uk/e38/
Forum: 7 Series - E38 (1995 - 2001) 04-27-2016, 10:35 PM
Replies: 16
Views: 780
Posted By Podmore
Start-up smoke can also be associated with...

Start-up smoke can also be associated with leaking valve stem seals especially on higher-mileage engines, but this is not a common problem on these engines AFAIK. However my understanding is that a...
Forum: 7 Series - E38 (1995 - 2001) 04-22-2016, 08:53 PM
Replies: 2
Views: 503
Posted By Podmore
Stock answer in the absence of a service history...

Stock answer in the absence of a service history which might show when various parts have been replaced - "It depends".

If the rear end bounces over bumps or the car feels 'wallowy' through the...
Forum: 7 Series - E38 (1995 - 2001) 04-22-2016, 07:50 PM
Replies: 11
Views: 707
Posted By Podmore
Unfortunately still not very clear but I'll take...

Unfortunately still not very clear but I'll take your word for it that it looks like "moisture". Given that you have the inlet manifold off and I can see what looks like a lot of carbon deposit,...
Forum: 7 Series - E38 (1995 - 2001) 04-21-2016, 07:35 PM
Replies: 11
Views: 707
Posted By Podmore
Not sure I understand the question, in the...

Not sure I understand the question, in the absence of a photo or other detail. Assuming you mean there is evidence of moisture (=water) inside the cylinder on top of the piston, what are the symptoms...
Forum: 7 Series - E38 (1995 - 2001) 04-21-2016, 07:12 PM
Replies: 6
Views: 517
Posted By Podmore
Most automotive paints these days use "clear over...

Most automotive paints these days use "clear over base" process. The base coat dries quite flat and needs a clear (2-pak) top coat to bring out the colour effect of the metallic or pearl pigments and...
Forum: 7 Series - E38 (1995 - 2001) 04-21-2016, 06:48 PM
Replies: 3
Views: 300
Posted By Podmore
I have the same problem - check brake lights...

I have the same problem - check brake lights comes on every once in a while, even though all lights seem to be working fine.

The system is very sensitive to resistance in the circuit and the...
Forum: 7 Series - E38 (1995 - 2001) 04-17-2016, 09:11 PM
Replies: 4
Views: 484
Posted By Podmore
With 145 views and no replies, I think everyone...

With 145 views and no replies, I think everyone else is thinking what I'm thinking - good luck wit dat!

Best bet would be to line up another E38 with everything in its proper place, and follow the...
Forum: 7 Series - E38 (1995 - 2001) 04-09-2016, 12:42 AM
Replies: 3
Views: 524
Posted By Podmore
Yeah, I know this is an old post (I love to rat...

Yeah, I know this is an old post (I love to rat back through the files to see what has not been resolved) but this problem has popped in in the forum from time to time and having had the same...
Forum: 7 Series - E38 (1995 - 2001) 04-06-2016, 12:38 AM
Replies: 1
Views: 328
Posted By Podmore
Low oil level can cause this; also failing 'A'...

Low oil level can cause this; also failing 'A' clutch and / or torque converter; or dirty filter causing fluid starvation to the clutches; or sticking valves in the valve body.

Crack one of the...
Forum: 7 Series - E38 (1995 - 2001) 04-06-2016, 12:26 AM
Replies: 3
Views: 599
Posted By Podmore
The "shakes" I assume relate to the car as a...

The "shakes" I assume relate to the car as a whole, not just the engine? In which case it is most likely the front suspension thrust arm bushings. When these start to fail, they allow the thrust arms...
Forum: 7 Series - E38 (1995 - 2001) 04-06-2016, 12:13 AM
Replies: 3
Views: 457
Posted By Podmore
Sounds like it could be the transmission heat...

Sounds like it could be the transmission heat exchanger (#1 here http://www.realoem.com/bmw/enUS/showparts?id=GG42-EUR-07-2001-E38-BMW-735i&diagId=17_0162 ) from the dimensions
Showing results 1 to 25 of 222

Forum Jump

All times are GMT -7. The time now is 10:21 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
© 2001-2015 performanceIX, Inc. All Rights Reserved .: guidelines .:. privacy .:. terms