Welcome to Bimmerfest -- The #1 Online Community for BMW related information! Please enjoy the discussion forums below and share your experiences with the 200,000 current, new and past BMW owners. The forums are broken out by car model and into other special interest sections such as BMW European Delivery and a special forum to voice your questions to the many BMW dealers on the site to assist our members!

Please follow the links below to help get you started!

Go Back   Bimmerfest - BMW Forums > Search Forums

Showing results 1 to 25 of 749
Search took 3.00 seconds.
Search: Keyword(s): ; Posts Made By: Monolith
Forum: E36/7 Z3 (1996-2002) Yesterday, 05:02 PM
Replies: 2
Views: 126
Posted By Monolith
If it's cyclic, you might check the rear wheel...

If it's cyclic, you might check the rear wheel bearings. How many miles on the car?
Forum: E36/7 Z3 (1996-2002) Yesterday, 04:59 PM
Replies: 4
Views: 232
Posted By Monolith
The zroadster.net forums are UK based. You might...

The zroadster.net forums are UK based. You might give that forum a shot as well.

I'm not familiar with the fault code names you've listed. You might have better luck listing the BMW three digit...
Forum: E36/7 Z3 (1996-2002) 09-17-2014, 05:10 PM
Replies: 25
Views: 7,890
Posted By Monolith
I would start with the easy and most likely...

I would start with the easy and most likely causes first. The easiest way is to get the BMW codes read at a dealership or independent BMW shop.

Separate out the airbag light from the rest. ...
Forum: E36/7 Z3 (1996-2002) 08-01-2014, 07:33 AM
Replies: 6
Views: 425
Posted By Monolith
Just for future reference - the A mode light...

Just for future reference - the A mode light should be lit all of the time. It is frequently burned out and thus it seems that only the M lights up. The tranny or engine can establish a "limp home...
Forum: E36/7 Z3 (1996-2002) 07-15-2014, 10:39 AM
Replies: 3
Views: 335
Posted By Monolith
http://www.318ti.org/forum/showthread.php?t=40440

http://www.318ti.org/forum/showthread.php?t=40440
Forum: E36/7 Z3 (1996-2002) 05-06-2014, 09:24 AM
Replies: 4
Views: 233
Posted By Monolith
Must be bad timing. I just looked at eBay and...

Must be bad timing. I just looked at eBay and only saw cat forward systems. Typically you can find Scorpion, Ansa, Sprint, Remus, etc. Are you looking for an upgrade or just a cheap replacement?
Forum: E36/7 Z3 (1996-2002) 05-06-2014, 08:54 AM
Replies: 4
Views: 233
Posted By Monolith
The 2.0 engine was a straight six engine...

The 2.0 engine was a straight six engine available only outside of North America. I assume you're asking about using the catback for the 2.0 on the 1.9? There's usually some aftermarket versions on...
Forum: E36/7 Z3 (1996-2002) 04-14-2014, 10:30 AM
Replies: 34
Views: 1,638
Posted By Monolith
You might also want to consider Sloan Kettering...

You might also want to consider Sloan Kettering (NYC) and MD Anderson (Houston, TX). Both top rated centers.
Forum: E36/7 Z3 (1996-2002) 04-05-2014, 02:25 AM
Replies: 8
Views: 541
Posted By Monolith
Usually the U-joints make the center bearing go...

Usually the U-joints make the center bearing go bad. Just replacing the center bearing only lasts a few thousand miles. The U-joints themselves are not easily replaced. Most opt for a...
Forum: E36/7 Z3 (1996-2002) 04-03-2014, 04:59 AM
Replies: 8
Views: 1,065
Posted By Monolith
"3" is the position for sport mode in the 4L30E...

"3" is the position for sport mode in the 4L30E transmission (unless you have the Euro version and then you have an "S" switch position).
Forum: E36/7 Z3 (1996-2002) 04-02-2014, 03:05 AM
Replies: 13
Views: 719
Posted By Monolith
That's the power steering reservoir. It uses ATF.

That's the power steering reservoir. It uses ATF.
Forum: E36/7 Z3 (1996-2002) 03-05-2014, 03:33 PM
Replies: 7
Views: 620
Posted By Monolith
There's one clip on each side of the box. You're...

There's one clip on each side of the box. You're probably not seeing the one under the silencer (orange arrow at top of pic).

The gray foam inside the box has probably disintegrated by now so...
Forum: E36/7 Z3 (1996-2002) 02-15-2014, 06:44 PM
Replies: 11
Views: 1,119
Posted By Monolith
The tan "Z3" embroidered are NLA. UK seller had...

The tan "Z3" embroidered are NLA. UK seller had some for around $200.
Forum: E36/7 Z3 (1996-2002) 02-08-2014, 06:42 AM
Replies: 10
Views: 719
Posted By Monolith
Glad to hear it all worked out. Thank you for...

Glad to hear it all worked out. Thank you for the updates!
Forum: E36/7 Z3 (1996-2002) 01-24-2014, 11:37 AM
Replies: 10
Views: 719
Posted By Monolith
Since you have lean conditions, you might check...

Since you have lean conditions, you might check for a vacuum leak in the intake system (past the MAF). In some automotive systems, it takes two fault cycles before the lean code will be set (you...
Forum: E36/7 Z3 (1996-2002) 11-22-2013, 06:23 AM
Replies: 5
Views: 612
Posted By Monolith
Unless you have ultra high mileage, a center...

Unless you have ultra high mileage, a center bearing failure is usually a symptom rather than a cause. A repeat failure in the short term points to bad ujoints, etc.
Forum: E36/7 Z3 (1996-2002) 09-27-2013, 08:10 AM
Replies: 6
Views: 522
Posted By Monolith
Put the transmission in sport mode and post the...

Put the transmission in sport mode and post the tranny's shift points. Should be significantly higher than 4500rpms. The cam sensor should be a BMW original part and not aftermarket.
Forum: E36/7 Z3 (1996-2002) 08-24-2013, 07:19 PM
Replies: 1
Views: 239
Posted By Monolith
It's the sensor for the heated jet washers for...

It's the sensor for the heated jet washers for the windshield, not the ambient air temp sensor.
Forum: E36/7 Z3 (1996-2002) 08-23-2013, 08:17 AM
Replies: 8
Z3 Roadster (E36/7) Clunk and vibrate at 2000rpm
Views: 626
Posted By Monolith
You can also check your differential mount. But...

You can also check your differential mount. But it would have to be toast before it would cause that much driveline issues. Engine mounts should also be checked since it occurs at certain...
Forum: E36/7 Z3 (1996-2002) 08-21-2013, 06:55 PM
Replies: 8
Z3 Roadster (E36/7) Clunk and vibrate at 2000rpm
Views: 626
Posted By Monolith
From a dead stop, accelerate hard while turning...

From a dead stop, accelerate hard while turning left (90 degree turn). If you get a pounding sound on the drive shaft tunnel, it's the ujoints. This maneuver will cause the drive shaft to hit the...
Forum: E36/7 Z3 (1996-2002) 08-21-2013, 05:27 PM
Replies: 6
Z3 Roadster (E36/7) Z3 Driveline Question
Views: 370
Posted By Monolith
It's not the rear shock mounts by chance? Mainly...

It's not the rear shock mounts by chance? Mainly clunking over bumps etc. Loading and unloading sounds like the diff bushing. If you can get it up on a lift, have someone load and unload the...
Forum: E36/7 Z3 (1996-2002) 08-21-2013, 03:26 AM
Replies: 6
Z3 Roadster (E36/7) Z3 Driveline Question
Views: 370
Posted By Monolith
Make hard acceleration left hand turns (90...

Make hard acceleration left hand turns (90 degrees) from a complete stop. If it clunks, it points to the ujoints. The clunking will come from the drive shaft tunnel rather than from the rear of the...
Forum: E36/7 Z3 (1996-2002) 08-20-2013, 04:41 PM
Replies: 6
Z3 Roadster (E36/7) Z3 Driveline Question
Views: 370
Posted By Monolith
If the CSB is bad, your ujoints in the drive...

If the CSB is bad, your ujoints in the drive shaft are bad. Drop the end of the drive shaft and make sure none of the joints bind in a full range of motion. Mine was from a dry arid climate and the...
Forum: E36/7 Z3 (1996-2002) 08-13-2013, 08:25 AM
Replies: 3
Z3 Roadster (E36/7) 1996 Z3 Wheel parts question
Views: 311
Posted By Monolith
Those are definitely not style 42's.

Those are definitely not style 42's.
Forum: E36/7 Z3 (1996-2002) 08-07-2013, 06:22 PM
Replies: 4
Views: 431
Posted By Monolith
Waiting for the tire smoking video.....

Waiting for the tire smoking video.....
Showing results 1 to 25 of 749

Forum Jump

All times are GMT -7. The time now is 10:00 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
© 2001-2011 performanceIX, Inc. All Rights Reserved .: guidelines .:. privacy .:. terms