DIY - My new fog light LED Halo's ! Check it out !
View Single Post
07-10-2010, 03:28 AM
Officially Welcomed to the 'Fest
Join Date: Aug 2009
Mein Auto: AC Schnitzer 745i Sport
View My Garage
Originally Posted by
Are they plug and play or do you have to splice wires? The wire looks too short in this picture.
I took some photo's during the prep of the LED Fog Halo rings :
This is what you get delivered....2 off 80mm LED Rings with LED on a white plastic ring :
First ring painted with Grey Primer (paint both sides to seal it better):
Painting second ring ...(just take your time and not paint the top of the LED itself) :
First ring painted Matt Black :
Both rings finished on LED side painted Matt Black :
Finally on back of the LED Ring.....I desoldered the short wires and soldered longer thicker guage ones .....then paint the connections to seal them :
To connect the RED wires to the Main Headlight Connector you just need 2 off Snap Fit Connectors which splice into the wires.....you only need one for each side......
Here's my Headlight Connector.......For each side Wire RED to
(Left Headlight wire - Gray/Green)
(Right Headlight wire - Gray/Blue)
....it's the bottom thinnest wire on the Headlight connector :
The Black wire just goes to an Earth Ground Nut on the car chassis ...which there are several to choose from....
My BMW ACS7
Last edited by TechFreak; 07-10-2010 at
View Public Profile
Find all threads started by TechFreak
Find all posts by TechFreak
View My Garage
Add TechFreak to Your Ignore List