View Single Post
  #12  
Old 01-06-2011, 04:41 PM
Ebonix Ebonix is offline
Officially Welcomed to the 'Fest
Location: Melbourne Australia
 
Join Date: May 2009
Posts: 234
Mein Auto: 1999 E39 540IA Steptronic
Quote:
Originally Posted by cn90 View Post
Couple things:

1. Did you preload the center bearing?

2. To insert image at step-by-step:
- Right click on the image you want and "Copy Image URL". For example you will see the 1st image as:

http://www.bimmerfest.com/forums/att...1&d=1294299314

- Then place the cursor where you want the image to be, hit the icon "Insert Image", then Paste the URL. You can leave the whole URL alone or shorten it to the picture id as below, the software of the forum only cares about attachmentid=261169, and not the strings of letters/numbers afterward:

http://www.bimmerfest.com/forums/att...hmentid=261169

Go back to your message and edit it and you will see, it is very easy to do this step-by-step picture thing. In fact much easier than replacing the Giubo!
G'day CN...

Centre bearing was ok so i didn't replace it, it went back into position when you tighten the bolts to the flex disk, no preload required unless you replace it with a new one.

Thanks for the tips, i'll try later and see if it works.

Cheers!
__________________


My EX daily chariot - '99 540IA Steptronic

Standard Cosmetic Mods - Staggered wheel set up, OEM ///M Steering Wheel, ///M spoiler, ///M grills, front lip, Muffler delete with 3" SS bent pipe and tip, the rest is stock.
Reply With Quote