So your finish came off again? You don't actually touch the steering wheel trim, do you? Sorry - a little BMW humor.
Originally Posted by Evlengr
Ok so get this. I drop the car off today. They agree to replace for the second time the worn/torn rubber finish on my steering wheel.
However they tell me that the rotos cant be done as the min spec 23.40 and my rotors are 23.47.
Well 3 months ago I brought them in and they told me they were 23.46. So they are either inaccurate in their calibrations which they swear by or my rotors are now getting thicker than thinner.
Or if the several 100'ths of an inch is not so big a deal then they should have done them three months ago in the first place.
This is why I never trust them.
I don't think the .01mm will do much. Just technician inaccuracy or they picked up more of a raised area.
So were you trying to get them replaced under warranty and the said they are still in spec?
It is frustrating!
My garage: 2007 BMW Z4 3.0si Manual, 2007 BMW X3, 2006 BMW 530xi
Retired: 1998 BMW Z3
Member of BMWCCA!
Last edited by madurodave; 08-30-2011 at 08:46 PM.