View Single Post
Old 03-07-2012, 04:26 AM
stuartjohn24 stuartjohn24 is offline
Officially Welcomed to the 'Fest
Location: Chippenham, Wiltshire, UK
Join Date: May 2011
Posts: 828
Mein Auto: BMW F01
Hi mortyx10,

THANK YOU! I tried this before work today and it works perfectly!

I was dead set against paying 100 for some tacky chinese CAN BUS module to enable this function.

I cant thank you and those involved enough for working this out and sharing this DIY!

One note to anyone else doing this, it may be obvious but I made a mistake in the MMI_E65.C02 file where I added the coding data at the end of the file, NCS Expert did not like that!

I realised that the CODIERDATENBLOCK : {00003021}..... needed to be in numerical order in the file, and not at the end i.e. not after 31XX etc...

Many thanks again!

Reply With Quote