If it weren't standard procedure to install a clutch, agreement perhaps would be a factor. This isn't a "change your clutch in a sandy ditch" scenario. You guys are too much
Originally Posted by drivinfaster
this sounds logical. however, i have had many stepped flywheels resurfaced.
never did a dual mass flywheel though...so i can't say for ceertain.
i'd go with this scenario over the clutch master myself. do you have a single mass flywheel available?? might be worth a shot at this point. i'm all out of any other possibilities at this venture, and i highly doubt there is any installer error. (not that *that* ever happens...
Wide Open Throttle Technologies (WOT-Tech)
The 1986 325es Delphin project LINK
Project 1988 325i sedan "Pinky" LINK