Thread: Ignition Fault
View Single Post
Old 06-02-2012, 08:39 PM
Traveler218 Traveler218 is offline
Registered User
Location: Huntsville, Al
Join Date: Jun 2012
Posts: 24
Mein Auto: 2007 Z4 3.0i Montego Blue
Ignition Fault

Hi; I am new to this form and was hoping I could get some help. my 2007 Z4 3.0i recently started missing when i accelerate. I was able to borrow a diagnostic code reader from a friend and read the fault code.

The only code showing is "P135B". which is identified as "Manufacturer Contrl Ignition System or Misfire." I have been unable to locate any definitive information about this code or what might have caused it to trigger. Does anyone happen to have knowledge abut this code or have access to a resource that might give a clue what causes it?

any help would be greatly appreciated.

Edit; I cleared the fault and drove the car for about 2 hours today, checking for codes every time i would stop. For the first 1 1/2 hours no problems. The car ran ultra smooth. then suddenly I had to slow way down to avoid hitting a bicycle rider. as I accelerated around him I got the miss again, and it happened several times over the next 5 miles. when I stopped I had the same P135B code again.

Last edited by Traveler218; 06-02-2012 at 08:52 PM.
Reply With Quote