No great breakthroughs so far.
Last night I activated FTMS. The RPA choice is just above the RDC FDL line (not RDC_SAFETY). It was set to nicht_aktiv, I changed it to aktiv. I now have an RPA ecu choice on my CAFD which has so many settings it's ridiculous. I was going through it, but just didn't have the time to delve deep into the tree.
I also adjusted two FDLs sitting in KOMBI that related to RDC, but my suspicion is that they are the FDLs that allow TPMS error codes to display on the guage cluster. Aktiv to Nicht_Aktiv.
This morning I started the car and reset the TPMS then drove away. Previously my TPMS display showed the pressure and temp icons (and green tires) but didn't give me anything else. I didn't get the dashes like many of you get. So after driving for about 200 ft I got the same display but with dashes now.
I'm going to change the RPA/KOMBI settings back to their original values one-by-one this afternoon to see what happens. Then I report back my findings.
Last edited by ImSW1; 06-08-2012 at 06:03 AM.