View Single Post
Old 08-03-2012, 03:54 PM
D4hwt D4hwt is offline
Registered User
Location: UK
Join Date: Jul 2009
Posts: 94
Mein Auto: E65 735i, Ducati1199
I have this job planned for when I get back home in a couple of weeks. As well as cyl 5-8 valve cover gasket. Did 1-4 last month. Hopefully 5-8 should be a bit easier.
I was gonna jack the motor up with a trolley jack as I don't have an engine lift either.
Did you have to remove the anti roll bar completely or just slacken off the mounts and tie it out the way?
I have dynamic drive but was just planning on taking the mounts off and tying the roll bar out the way.
Keep up the good work. I shall be watching this post with interest!!
Reply With Quote