Bimmerfest - BMW Forums - View Single Post - Installing wind deflector
View Single Post
Old 09-21-2012, 04:49 AM
645/333's Avatar
645/333 645/333 is offline
Location: uk
Join Date: Jun 2010
Posts: 1,632
Mein Auto: BMW 640i SE Convertible
Hi ! when you look at your current roll bar covers can you see 4 screw holes ? 2 each side on the inner!! If yes then you just attached the wind deflector brackets to these 4 holes about 5 mins work if that, then just fit the deflector.
If you don't have these 4 holes then you do not have the correct covers on your roll over bars and have to buy the correct ones. They come off upwards not and not split as you would think..... I have heard comments that this can be a pain so watch you don't break the plastic clips/tabs
You could save money by making a template of the wind deflector brackets and drill the 4 holes ensuring they are level both sides.....I am not sure about the screws holding as this is only plastic...but some have done this as a fix..
Or look on Ebay and see if any for sale ?????/

Always said I would go back to a 6 series

Last edited by 645/333; 09-21-2012 at 04:51 AM.
Reply With Quote