DO NOT ANTISEIZE THE BOLTS
i have a dewalt 18V impact wrench to speed things up. http://www.amazon.com/DEWALT-Bare-To...eywords=dw059H
i can finish a swap in 20 minutes with that, if i use two jacks to lift one side at a time (you can actually use 1 at the rear jack point, but i cannot recommend doing this)
i put a quick swipe of antiseize on the centerbore of the wheel, nowhere else, never had an issue getting the wheels off.
finish off the job by torquing the lugs to 88 ft/lbs, then retorquing a few hundred miles later. my personal favorite torque wrench is a split beam one.
Past: 2001 330i ZSP/ZPP/Step
Past: 2004 S60R 6MT Sport
Past: 2007 335i 6MT ZSP/ZCW/322/655
Past: 2010 335xi ZMP/ZCW/ZPP/PPK/PE
Present: 2013 335i 6MT ZMM/ZDH/ZTP/3AG/494/508
Current Homeland Threat Level:
Last edited by Orient330iNYC; 11-16-2012 at 03:47 PM.