Bimmerfest - BMW Forums - View Single Post - Dinan stage 2 on 650 MY12
View Single Post
Old 11-18-2012, 02:51 PM
haastx10 haastx10 is offline
Location: Texas
Join Date: Feb 2012
Posts: 172
Mein Auto: 2015 M5 DINAN
Stage 3 numbers

Just had Stage 3 Dinan installed on my '12 650iC. Had car dyno'd before and after;

Stock: 328 WHP on dyno, 18% loss to wheels calculates to 400 hp stock at the flywheel
Stage 3: 457 WHP on dyno. Calculates to 539 hp at flywheel, with Dinan exhaust

I will post the pull sheets w torque once I get them next week.

Really impressed with the performance on the 650. The lighter weight of the car makes it break traction now with every gear change during wide-open throttle. And the exhaust note is awesome... Not too much but definitely aggressive. There is no throttle lag and drivability is fantastic. This is not cheap HP but you definitely get performance with software and bolt on exhaust! This is how this car should have been set up from the beginning!! And it drives fantastic!

On a side note, I also have a 7 series that previously had stage 2, which had to be reinstalled after dealer erased during software upgrade recently. After the reinstall, I noticed a definite throttle lag, almost a two-step process during light acceleration that wasn't there before. Dinan said that this was due to the vehicle adapting after the complete software reinstall. I never noticed that the first time around however. Now that I installed the stage 3 with exhaust, there is no lag on the 7 whatsoever so I'm not sure that I'm buying the compatibility of stage II with the new BMW software. Unfortunately, I couldn't dyno the 7 as well as it's a long wheelbase, and would not fit on their four-wheel-drive dyne.
2015 BMW F10 M5, Space Gray, Dinan Stage 1 Engine, Exhaust, Coil Over Suspension, Sway Bars, Vorsteiner Staggered 9 /10.5 '20's, Custom Coded.

Reply With Quote