Remove two 8mm screws at top mounting tabs of headlight.
Remove lower headlight trim piece; there is a mounting tab on the side near the grille; DONT BREAK IT.
Remove two 8mm screws holding headlight bracket to chassis (tape a socket onto a long 1/4" ratchet extension)
Remove two 8mm mounting screws holding headlight to mounting bracket.
Carefully wiggle headlight and mounting bracket free.
You dont need to remove the light to replace the bulb.
Remove the c-shaped clip holding the rubber bellows to the bulb housing.
Pull the bellows back.
Remove the three Torz screws holding the bulb surround; remove the surround
Unclip the lead from the bulb (1/8 turn).
Remove the bulb collar (1/8 turn).
R+R bulb. Do NOT touch the glass capsule.
Originally Posted by Fast Bob
JUST...LOOK...UNDER...THE...CAR....for Chrissakes....it`s like checking to see if a dog is male or female....
Originally Posted by smolck
A bimmer with forced induction should have a proper manual gearbox. Anything less is like french kissing your sister.