View Single Post
  #3  
Old 11-26-2012, 08:10 PM
Medicus Medicus is offline
Marine
Location: Hawaii
 
Join Date: May 2012
Posts: 93
Mein Auto: 2005 BMW 645Ci
Yes that is all that you need to do its a PITA to put back on though. Easiest way that I found to pull out the valve cover was a screw driver in the oil dip stick tube with mild pressure angle the cover up towards the fender until it clears the oil tube. Then pull up just a little until you are over the sensor. Once you get that far just pull it straight towards the front and it will be out. Also when putting it back in make sure that the bottom bolts thread on first. I ran into problems with the cover sitting on properly. If you have any issues with bolts then something is off. I had to do mine again because it wasn't on properly.
__________________

Last edited by Medicus; 11-26-2012 at 08:11 PM.
Reply With Quote