Bimmerfest - BMW Forums - View Single Post - Just changed tranny fluid
View Single Post
Old 11-29-2012, 03:55 PM
BuiltnBoostedZ BuiltnBoostedZ is offline
Registered User
Location: Tx
Join Date: Jul 2011
Posts: 89
Mein Auto: X3 xDrive35i & 350Z TT
Originally Posted by cmpcpro View Post
Thanks, but does this cover the 03 745i? Can I check fluid from the computer on my car? Also, when I start car do I put plug on first and remove again, or just leave off and screw in as per above? I watched a video online and the guy was going from P to N D and R, but he didn't do the 1-6. Is he correct or these directions? Do I bother with N and R? Should I just do all? Do I need to check fluid again after going through the gears? Thanks! Keep in mind I am not dropping pan it was done a while back. Just using drain plug and fill plug. I will make sure fill plug loosens before proceeding with anything.
Checking fluid level:
Connect BMW Diagnosis and Information System (DIS) or BMW MoDiC to vehicle.
Call up Service functions (drive).
Carry out fluid level check in accordance with instructions.

If you don't have access to these tools...just make sure once you go through the operations like stated above...once you open the filler neck on the pan that a stream of fluid tries to come out...that's when you know you have enough in there. If no fluid comes out, add more fluid.
350Z TT - SOLD!
2004 745Li - SOLD
2011 X3 xDrive35i

Last edited by BuiltnBoostedZ; 11-29-2012 at 03:58 PM.
Reply With Quote