Bimmerfest - BMW Forums - View Single Post - EAS | ESS VT2-500 Supercharger Build - E46 M3
View Single Post
  #4  
Old 12-03-2012, 03:35 PM
tom @ eas's Avatar
tom @ eas tom @ eas is offline
european auto source
Location: SoCal, CA
 
Join Date: May 2004
Posts: 5,879
Mein Auto: BMW
During the installation, we noticed that 2 of the 6 coils were badly corroded - recommending new coils/spark plugs as an extra precaution. Maintenance is key.

After the install was completed, we gave her a quick wash and strapped down on the dyno:





Dyno sheets

STD


SAE


Conditions


SAE/BOOST


CSL SMG Transmission software was also flashed as an added bonus.

It's been raining here in SoCal for the past week, which explains the 70% humidity figure. Boost is not reaching full potential (should be 7.5lb), so more power is at tap. We may be switching the pulley for a slightly smaller version as per ESS's recommendation to get slightly higher numbers after adaptation.

ESS has simply been more than supportive through the entire installation, even after hours. This IMHO, speaks volumes for the systems.
Reply With Quote