Thread: brake issue
View Single Post
  #27  
Old 01-15-2013, 09:48 AM
yxd0018 yxd0018 is offline
Officially Welcomed to the 'Fest
Location: west new york, nj
 
Join Date: May 2011
Posts: 102
Send a message via MSN to yxd0018 Send a message via Skype™ to yxd0018
Mein Auto: 328i
In case of I found frozen caliper, I heard it can recur even I push the piston back. I read "If the holes in the caliper where the pins pass through are worn oversize, then a new caliper and pins are required. Except in cases of early failure of one caliper, calipers are often replaced in pairs, the logic being that if one caliper has failed, the other one is not far behind. It all depends on the nature of the failure."
So if I decide to replace the caliper,
1. do I need to replace the caliper bracket where the guiding bolt screw into?
2. do I need to replace caliper on both sides of axle?
3. do I need to replace the guiding bolt as well?
4. do I need to put brake grease on the guiding bolt as well?
5. if I need to flush the brake fluid and looked at bleeding brake I worry that my only bmw jack is not up to the job. What's recommended here if I only have one jack?
6. where is the bleed screws? The one connect to the caliper piston?

Thanks.

Last edited by yxd0018; 01-15-2013 at 10:59 AM.
Reply With Quote