Bimmerfest - BMW Forums - View Single Post - HELP PLEASE Reset Z3 oil service light
View Single Post
Old 02-01-2013, 04:47 PM
DreamnZ DreamnZ is offline
Registered User
Location: Orange county, CA
Join Date: Jan 2013
Posts: 84
Mein Auto: 2001 BMW 330ci VERT
Originally Posted by z3-o1 View Post

Turn the ignition switch to position two (2). Connect the clip end of the jumper tool to a good ground in the area of the data link connector. Connect the pin end of the jumper tool to pin seven (7) of the data link connector and remove it after the appropriate time, depending on which reset you are doing. Replace the data link connector cap and turn off the ignition switch. Check to see if the reset worked by starting the car and seeing if the lights go out. If they do, good job!"

10 secs should do it let me know how you get on

I'm a bit confused, and therefore have to start by apologizing.
What to you connect? A wire? What's a jumper tool? Is this like my jumper cable?
This is a really good trick and I would really like to know how it's done.
Thanks in advance for clarifying.
Reply With Quote