BimmerFest BMW Forum banner

US s50+72mm snail+e30=?

3K views 6 replies 6 participants last post by  Tkaczuk 
#1 ·
 
See less See more
1
#2 ·
= busted engine and tears. Could be fun for a few minutes though.
 
#6 · (Edited)
Forged 8.5:1 pistons
ARP everything (head, mains, rods)
aline honed mains/rods
honed/decked block
super lightweight lifters
115lb (open) valve springs
3 angle valve job
Late model retainers/keepers
Fidenza 3pc 13lb flywheel
ACT HD pressure plate/6 puck sprung disk
Gapless top rings
Napier second rings
Total seal oil control rings
(all rings filed within .001")
Good & Tight manifold
72mm Precision Power turbo
Starting with 42lb/hr injectors
24x12x3" BPMC intercooler
Condor Speed Shop solid mounts
ZF gearbox
2.93LSD

We will be hacking the Motronic (have been writing chips for a decade) to start out, but have MS2 waiting for after break in and for larger injectors.

Beginning goal is a smooth pulling 400whp with the Motronic.

I think the bigger worry is axles and/or driveshaft.

....best part is, this is going in a Pink e30 :D
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top