I have a hardtop that i bought for my z3 a couple of years back. I want to install it and i have been trying to find out what parts i need. I don't want to do the defroster or any sort of wiring, i just want to get it in and go. So my question is what parts do i need if i want to install it without the defroster? Do i need any seals of some sort so it doesn't leek or should it be good if i just clamp it down?
There is mounting kit that must be installed on your car. It is basically some brackets that are installed at the top of the B pillars on the door frame (nearest the locks on the door).
There is also an optional hardtop spacer kit that provides some plastic pieces that help you align the hardtop so it doesn't scratch paint or leak.
Also had one more question, if i do not have an electric top at the moment, when i buy the mounting kit can i hook up the rear defroster or is that going to be a lost cause?
If you don't have an electrohydraulic top (not available until 1998), then defroster switch installation will require some disassembly of the rear console. This is rather tedious though not difficult. The BMW instructions can be a bit hard to decipher but overall it is a fun project.
Do you guys know how to take those foam pieces out when you are getting ready to put the hardtop in?.....do you just pull them out?
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
BimmerFest BMW Forum
11.4M posts
753.1K members
Since 2001
A forum community dedicated to BMW owners and enthusiasts. Come join the discussion about Bimmerfest events, production numbers, programming, performance, modifications, classifieds, troubleshooting, maintenance, and more! Bringing the BMW community together.