Hello all and as much as it pains me to post a question I really need some help. I have searched but no luck with the info I need so here goes.
I have a 95 740i that has a cut wire past the oxygen sensor connector. The actual O2 sensor on the drivers side pre cat is in place and the male/female connection is fine. Once you pass where the connection is heading towards the engine it is broken. The wire was on the exhaust and burned and basically cut in half. I have been searching to figure out where the plug goes after the connection. The only diagrams I found are through the exhaust which shows the plugs but not where they lead to , what they plug into next or how it is routed.
Does anyone know where I can find the information I have looked through endless schematics and diagrams with no luck. I would like to replace the wire that is broken with the correct part from where ever it connects leading to the oxygen sensor. Ive been using the forum and usually I can find the information but this time I am stuck , To be clear I guess I would ask where does the wire come from that plugs into the oxygen sensor? Im guessing ECU or Fuel management? I am hoping that it is just another plug at the opposite end because I am color blind and can not rewire things.
after a MAF, thermostat housing, OSV, vacuum hoses and sparkplugs Im almost there and Im pretty sure this is my last problem so thanks for all the help so far and any help here would be great.
I have a 95 740i that has a cut wire past the oxygen sensor connector. The actual O2 sensor on the drivers side pre cat is in place and the male/female connection is fine. Once you pass where the connection is heading towards the engine it is broken. The wire was on the exhaust and burned and basically cut in half. I have been searching to figure out where the plug goes after the connection. The only diagrams I found are through the exhaust which shows the plugs but not where they lead to , what they plug into next or how it is routed.
Does anyone know where I can find the information I have looked through endless schematics and diagrams with no luck. I would like to replace the wire that is broken with the correct part from where ever it connects leading to the oxygen sensor. Ive been using the forum and usually I can find the information but this time I am stuck , To be clear I guess I would ask where does the wire come from that plugs into the oxygen sensor? Im guessing ECU or Fuel management? I am hoping that it is just another plug at the opposite end because I am color blind and can not rewire things.
after a MAF, thermostat housing, OSV, vacuum hoses and sparkplugs Im almost there and Im pretty sure this is my last problem so thanks for all the help so far and any help here would be great.