Hi Guys,
This is my first post I need some advice, I recently slightly unclipped my front bumper towards the right. The kerb was higher than expected and the bumper was forced on as I was moving forward slowly. I then reversed the car to get it off the kerb and the bumper unclipped it self on the right side if sitting in car. I then immediately noticed the PDC fail message appearing. I think I may have unclipped the wiring. The back has now also stopped working. It’s my understanding that the front clip if disconnected will shut off the back also.
Is there any way I can access the clip/main PDC connection without having to take off the whole bumper? Or pay hundreds of pounds to a BMW garage.
Any help, images, diagrams would really be appreciated.
Its a 2006 520M sport.
This is my first post I need some advice, I recently slightly unclipped my front bumper towards the right. The kerb was higher than expected and the bumper was forced on as I was moving forward slowly. I then reversed the car to get it off the kerb and the bumper unclipped it self on the right side if sitting in car. I then immediately noticed the PDC fail message appearing. I think I may have unclipped the wiring. The back has now also stopped working. It’s my understanding that the front clip if disconnected will shut off the back also.
Is there any way I can access the clip/main PDC connection without having to take off the whole bumper? Or pay hundreds of pounds to a BMW garage.
Any help, images, diagrams would really be appreciated.
Its a 2006 520M sport.