|
|
||||||
|
7 Series - E65 / E66 (2002 - 2008)
Discussion pertaining to the flagship BMW here. |
|
|
|
Thread Tools | Display Modes |
|
|
|
#1
09-29-2012, 02:36 PM
|
|||
|
|||
|
Engine died going around corner
Coming downhill then turning onto my street, the engine died and wouldn't allow me to restart for a good minute or so. All the while sitting in the middle of the intersection. Gas tank was half full. An error message popped up for a few seconds that said something about "Anti-Roll" and "Curves" then went out. A lot going on while facing oncoming traffic, car wouldn't start and trying to read the dash! Car is running fine now, but worried that the next time my wife may be driving. Took to dealer and they want $150 (non-refundable) to diagnose because no faults were found. Thoughts?
|
|
#2
09-29-2012, 05:12 PM
|
||||
|
||||
|
Lose battery connection?
|
|
#3
09-29-2012, 06:46 PM
|
|||
|
|||
|
Smart idea is to read errors from CAS and other modules
|
|
#4
09-29-2012, 09:50 PM
|
|||
|
|||
|
go search for Integrated Power Supply Module in the forum. $120 if DIY.
|
|
#5
09-30-2012, 11:53 AM
|
||||
|
||||
|
There are other KNOWN issues related to the suspension that throws a code and usually puts the car in "limp mode". Looks like yours simply skipped that "meddlesome" intermediary step. Try searching on active suspension or other similar words.
__________________
  '12 X5d Sapphire/Black/Bamboo, Sport (ZAP), Premium (ZPP) & Premium Sound(ZPS) packages: 20" 214's, OEM Hitch '11 Victory Ness Cross Country!!! GONE - '06 750Li Sapphire Black/Creme&Black (Loadeddddd)
|
|
#6
09-30-2012, 01:36 PM
|
|||
|
|||
|
The error message said something about anti=roll or something around curves but was only on few a couple of seconds. Once the car started and did a check everything was ok, according to the car.
|
|
#7
10-02-2012, 01:13 PM
|
|||
|
|||
|
I had that and one other message. Wouldn't start after several attempts to start. Took it in codes said faulty crank shaft position sensor. $380.00.
__________________
Repairs 2012 wishbone & steering rack Rfmd hydro steering gea combination nu Ball Joint Tension strut with hydr Switch unit steering column Coils 5&7 and new spark plugs Faulty DSC Control Module Fuel Gauge Leaking Crank Case Vent Valves Power Steering pump, washer pump and grommont, Crank Shaft position sensor Total $13,481.37 in one year  my mechanic swears all these parts are re engineered to work better than the originals lol
|
|
#8
10-03-2012, 02:26 AM
|
|||
|
|||
|
Car still running fine since. Did check all fluids, especially steering and suspension reservoir; was a little low. Oil was a quart low. Took it back to dealer since it was just recently serviced and made sure ALL fluids were "topped off" and all good...so far!
|
|
#9
10-03-2012, 05:53 AM
|
||||
|
||||
|
Quote:
Your signature scare me 
__________________
 '11 328i '03 745Li '03 Acura TL-S '02 Infiniti QX4
|
|
#10
10-03-2012, 01:49 PM
|
|||
|
|||
|
Quote:
__________________
Repairs 2012 wishbone & steering rack Rfmd hydro steering gea combination nu Ball Joint Tension strut with hydr Switch unit steering column Coils 5&7 and new spark plugs Faulty DSC Control Module Fuel Gauge Leaking Crank Case Vent Valves Power Steering pump, washer pump and grommont, Crank Shaft position sensor Total $13,481.37 in one year my mechanic swears all these parts are re engineered to work better than the originals lol
|
|
|
| Bookmarks |
| Forum Navigation | |||||||
|
Today's Posts Search | ||||||
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
