|
|
||||||
|
7 Series DIY
Do It Yourself forum dedicated for 7 Series BMW Owners |
|
|
Thread Tools | Display Modes |
|
#18
03-07-2012, 04:26 AM
|
|||
|
|||
|
Hi mortyx10,
THANK YOU! I tried this before work today and it works perfectly!  I was dead set against paying £100 for some tacky chinese CAN BUS module to enable this function. I cant thank you and those involved enough for working this out and sharing this DIY! One note to anyone else doing this, it may be obvious but I made a mistake in the MMI_E65.C02 file where I added the coding data at the end of the file, NCS Expert did not like that! I realised that the CODIERDATENBLOCK : {00003021}..... needed to be in numerical order in the file, and not at the end i.e. not after 31XX etc... Many thanks again! Stuart 
|
| Bookmarks |
| Forum Navigation | |||||||
|
Today's Posts Search | ||||||
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode
