I want to tap into the fuse block to install a V1 radar connection behind the glove box. Intend to use an add a circuit fuse tap and want a circuit that turns on/off with ignition.
There is no chart I can find telling what the fuses behind the glove box are for. Can any one tell me which fuse to use with the add a circuit for a radar install or where i can find, get a diagram of the board and it's functions?
I'm up in the Colorado Mt's and over 150 mile from any dealer. Thanks in advance
Do not want to tap into a wire, want to connect direct to fuse box circuit. Had seen similar article about the overhead and wire. Do not want to fiddle with removal of light console either. Thank you for quick reply.
Anyone know of which fuse to use on fuse block behind glove box or where to see what the fuses are in a diagram? Please?
Can't believe no one out there has done a direct wire to the fuse block and there is no place nor anyone who knows what the fuses are for on the block? Please?
I'm over 150 mile from any dealer and sure would like to know what fuse to tie onto.
Someone can help-------can't you??
Found fuse diagram by rear(trunk) fuse box and it included the diagram for the front, glove box area, fuses also. Have identified numbers 54 and 65 as useable to tap into for a radar. {In case anyone cares}.
Now---does someone know where an explanation to the symbols on the diagram can be obtained? Know a few, but would like a complete list.
54 and 65 did not seem to turn off right away for me, but 21 worked, switches off right away.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
BimmerFest BMW Forum
11.4M posts
753.1K members
Since 2001
A forum community dedicated to BMW owners and enthusiasts. Come join the discussion about Bimmerfest events, production numbers, programming, performance, modifications, classifieds, troubleshooting, maintenance, and more! Bringing the BMW community together.