BimmerFest BMW Forum banner

Has anyone got this kit on their OBD 2 E36?

639 views 5 replies 2 participants last post by  E36 Phantom 
#1 ·
http://www.m50manifold.com/

M50 Manifold Conversion
For 1996 - 2000 BMW E36 3 series and E36/7/8 series

ANNOUNCEMENT - FLAT RATE INTERNATIONAL SHIPPING NOW OFFERED ON KIT#2 - Kit #2 only shipping is $55USD($30USD Canada/Mexico) and is Express Mail International, 5-7 days transit. Please use the order form to order directly. MAKE SURE YOUR SHIPPING ADDRESS IS CORRECT IN YOUR PAYPAL ACCOUNT AND PREFERABLY A VERIFIED ADDRESS.

ANNOUNCEMENT - NEW TROUBLE SHOOTING GUIDE AVAILABLE HERE:

TROUBLE SHOOTING GUIDE - CLICK HERE
info@m50manifold.com
PIC OF NEW 1 PIECE SILICONE HOSE

3 colors of hose

Use these links to learn more about this modification and BMWs in general:

http://forums.bimmerforums.com/forum/index.php?referrerid=62700

http://forums.bimmerforums.com/forum/showthread.php?t=1393269

http://forums.bimmerforums.com/forum/showthread.php?t=1545213

PIC OF NEW 1 PIECE HOSE SHOWN INSTALLED WITH ALL ACCESSORIES AND BRACKETS MOUNTED NORMALLY

Why would you want to change your intake manifold? Earlier year model motors had larger intake manifolds that flow considerably more intake air. Your later model engine will produce more horsepower with the earlier, larger, more freer flowing manifold.

1995/earlier - 1996/later

The earlier model manifold has nearly 60% larger intake runners and will flow a much higher volume of air at high RPMs than the later model manifolds

This kit is the most economical and complete kit on the market.

No other kit includes a throttle body seal that is the proper size.

No other kit includes brackets that allow you to easily remount the crank case vent valve, the idle control valve, and the dip-stick back into their original locations.

No other kit with a hose type adapter comes completely assembled and ready to bolt on to your OBDII accessories.

No other kit comes with 24/7 worldwide cell phone install support.
 
See less See more
#2 ·
No, because it's dumb.

Unless tot spend most of your time at HIGH RPM, the extra flow is not needed and the venturi on the M52 mani helps increase the volume of air entering the cylinder at lower speeds.

C:\>Sent from my 386 using MS-DOS__
 
#5 ·
Well, :p !!!!!!

C:\>Sent from my 386 using MS-DOS__
My new commute to work is all back roads, zero traffic (as in rush hour traffic goes in the opposite direction), and a complete blast!!!!!!!! I love this new job mainly because of the commute. It really keeps my BMWs in good working order by being able to open it up a little.
 
#6 ·
My new commute to work is all back roads, zero traffic (as in rush hour traffic goes in the opposite direction), and a complete blast!!!!!!!! I love this new job mainly because of the commute. It really keeps my BMWs in good working order by being able to open it up a little.
Ah man, reverse commute must be nice. Jelly.

C:\>Sent from my 386 using MS-DOS__
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top