I have a replacement cup holder (front-passenger side; '08 X3 ), and hope to remove the old broken one and install the new one myself.
Are there any "tricks" to this DIY project? The unit has two tabs along the top edge (must slide under the dash trim?) and 3 or 4 snap-in posts on the back side...very Germanic design, I say.
Any DIY advice will be appreciated.
relinuca
Are there any "tricks" to this DIY project? The unit has two tabs along the top edge (must slide under the dash trim?) and 3 or 4 snap-in posts on the back side...very Germanic design, I say.
Any DIY advice will be appreciated.
relinuca