BimmerFest BMW Forum banner

Z3 Fan switch oring?

2K views 2 replies 2 participants last post by  grecken 
#1 ·
Replacing my radiator and just removed the fan switch and there was no oring. Should there be? The Bently manual says to replace the oring. Thanks

2000 Z3 2.3 with 2.5l motor.
 
#3 ·
Thanks for the reply, Blacklane. Realoem shows one on the 2.8 nd 1.9, but not on my specific motor. I was told by an online retailer, that it was not used on my application. So, since it came w/o it from the factory (as far as I know, no one had ever touched it), I went back w/o it. Did not seem to be leaking befote....I'm probably being a little overly concerned about it. Thanks again.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top