
|
|
||||||
|
E60 (2004 - 2010)
BMW 5-Series (E60 chassis) was first seen in the Unites States in the fall of 2003 with a 2004 Model Year designation. The E60 is now available as a 528i, 528xi, 535i, 535xi, 550i and a 535xi sports wagon! -- View the E60 Wiki |
|
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
battery problem
pls what do you know about intelligent battery sensor? because my battery does not suvive 24hours.
|
|
#2
|
|||
|
|||
|
pls what do you know about inteligent battery sensor? because my battery does not last 24hours and i dont know what the problem is.
|
|
#3
|
|||
|
|||
|
Ummm - can you tell us a little more? Like how old is the battery! When did this start? We're there any other issues before? How often do you drive - and the distances.
__________________
2008 E61/Monaco Blue/Natural Brown/Premium/Sport/Logic 7/Sirius/Escort 9500ci, Conti DWS. Build Date 1/08. HPFP replaced 6/10 and 4/11 Fuel Injectors replaced 3/11. Battery replaced 5/11 (warranty), sunroof seal replaced 10/11 free under SIB 540409. Pads and rotors replaced 11/11 under maintenance. Carbon buidlup on valves cleaned under maintenance 11/11. 59K miles. Original owner. BMWCCA Member. Route 66 Easy Street Warranty. |
|
#4
|
|||
|
|||
|
i bought a new battery 3 weeks ago after changing my car DME and CAS.
|
|
#5
|
||||
|
||||
|
The IBS is located inside the negative battery cable and sold as one unit. BMW has revised this part 3 times and is currently only selling the 4th generation version. The latest version uses a different harness pinout, so in addition to the replacing the IBS by replacing the negative battery cable, you also need the option harness adapter.
The IBS will not throw a CEL if defective but will throw fault codes into the ECU which can be read during a typical diagnostic scope. Usually a defective IBS can be identified quickly because it will throw many hundred faults when it goes bad. You can replace the IBS without any need for additional coding or updates, simple DIY task but the parts will run around $270. When you replaced your battery, if you did not replace the IBS at the same time, you would need to have reset the IBS to properly charge the new battery. There are a number of threads on the process to reset the IBS, this is a fairly simple task w/ the right setup. If you did an AGM battery replacement, then in addition to the IBS reset you may also need to code a new amp hours value for correct operation. |
|
| Bookmarks |
| Forum Navigation | |||||||
|
Today's Posts Search | ||||||
| Thread Tools | |
| Display Modes | |
|
|