FS Parting out 2002 m54 2.5l engine from a 325i

Engine came out of 02 325i with 85k at time of removal. Engine ran hot but not killed, blown head gasket. Replaced engine due to having another m54 available with comparable mileage and replacement was cheaper than quotes to repair head gasket. Many parts available such as, intake, wiring harnesses, fuel rail, injectors, ignition coils, valve cover, timing cover, DSA Valve, Idle Control Valve, Throttle body, Vanos Assy, Crank Position Sensor, Exhaust side Cam Position Sensor, bottom main pulley, Oil Pan, Oil filter housing, Bosch 120amp alternator, Exhaust Manifolds w/CATs and Front and Rear O2 sensors, Engine Covers, Camshafts, Crankshaft, and more. I will post pictures later. I am at 35768 and have PAYPAL. Contact me with any questions. All parts will be sold below fair market value for used parts plus shipping.

How much for DISA valve shipped to 30047?

I have someone who has made an offer for it. However, I have not heard from him in a few days. I will send an email tomorrow and see if he still wants it. I quoted it for 75 plus shipping.

DISA sold yesterday.
Still have lots of engine parts, such as: ignition coils, exhaust cam position sensor, crank position sensor, complete intake, throttle body, fuel rail, injectors, complete wiring harness(all required for engine), factory exhaust manifolds w/cats and with good/working o2 sensors(front and rear) main bottom pulley, valve cover, engine covers, bosch alternator, oil filter housing, water pump, complete block with crank and all pistons and rods, both camshafts, complete vanos assembly, oil pan, also have set of front strut assemblies and rear coil springs. Many more parts available, I have PayPal and will sell all parts below market value for used parts.

Exhaust cam position sensor and DISA sold. Still lots of parts available.

Bump for good seller

lots of parts still available. All must go. Prices are dropping.

Bump

Bump

Do you still have parts available? If so, what do you have? I am looking at getting a new valve cover, and after a compression and leak down test, I may need some other parts.

Originally Posted by 2of3bmws

Do you still have parts available? If so, what do you have? I am looking at getting a new valve cover, and after a compression and leak down test, I may need some other parts.

I do Valve cover would be hard on shipping, price $60.

Originally Posted by SWISS

I do Valve cover would be hard on shipping, price $60.

Is your valve cover for a 2002 325i with an M54 engine by chance?

My valve cover is like new. Give me a zip and i'll get you a quote for shipping. I have vanos, head, manifolds, o2 sensors, wiring harnesses, several sensors, alternator, intake, icv, etc...

Originally Posted by 2of3bmws

Is your valve cover for a 2002 325i with an M54 engine by chance?

Yep and I have the head and vanos and all hardware too. Take $200 for all of it you pay shipping.

Originally Posted by SWISS

Yep and I have the head and vanos and all hardware too. Take $200 for all of it you pay shipping.

Sweet. I will PM my zip.

Originally Posted by ckmckm

My valve cover is like new. Give me a zip and i'll get you a quote for shipping. I have vanos, head, manifolds, o2 sensors, wiring harnesses, several sensors, alternator, intake, icv, etc...

Sweet. I will PM my zip.