Welcome to Bimmerfest -- The #1 Online Community for BMW related information! Please enjoy the discussion forums below and share your experiences with the 200,000 current, new and past BMW owners. The forums are broken out by car model and into other special interest sections such as BMW European Delivery and a special forum to voice your questions to the many BMW dealers on the site to assist our members!

Please follow the links below to help get you started!

Go Back   Bimmerfest - BMW Forums > BMW Model Discussions > 3 Series / 4 Series > E46 (1999 - 2006)

E46 (1999 - 2006)
The fourth generation 3 Series (E46 chassis) was introduced in 1999 and set the standard for engineering and performance during it's years of production including being named to Car & Driver's 10 best list every one of those years! ! -- View the E46 Wiki

Reply
 
Thread Tools Display Modes
  #1  
Old 11-24-2012, 10:44 AM
ventsyv ventsyv is offline
Officially Welcomed to the 'Fest
Location: Baltimore, MD, USA
 
Join Date: Jul 2008
Posts: 1,193
Mein Auto: 03 BMW 330ci
Diagnosing a VCG leak

I was having a pretty massive oil leak which I traced to the area under the intake. I had the PCV replaced along with all the hoses from the kit, as well as the oil filter gasket.

The rate of oil loss was reduced, but not completely eliminated. After inspecting the engine bay for traces of fresh oil, I found some on the metal trim on the passenger side that shows below the plastic covers.

I suspect I have a leaking VCG. The car has 130 000 miles and is still on the original VCG, so it's not a surprise that it leaked, but is there any way to confirm that?

I replaced the spark plugs about 50,000 or 60,000 miles ago. If the VCG leaked, do I need to replace the sparkplugs? If I remember correctly, there are little gaskets for the plugs, right? Chances are they went bad too right?

Last edited by ventsyv; 11-24-2012 at 10:58 AM.
Reply With Quote
Advertisement
  #2  
Old 11-24-2012, 03:01 PM
QAfred QAfred is offline
Officially Welcomed to the 'Fest
Location: Panhandle of Florida
 
Join Date: Aug 2008
Posts: 919
Mein Auto: 328i, 330ci, R1200C
If that aluminum heat shield you refer to has oil residue on it you just confirmed the VCG has an oil leak. Look your parts up on realoem and you can see the illustrated parts breakdown (IPB), for your model.

The new VCG will also have the gaskets that seal around each spark plug included, but the rubber washers, that go under each bolt, should also be replaced since these are what push down on the cover to seal it. The VCG bolts bottom out when tight so be careful not to overtoque and break them, in this case when the stop turning they are as tight as they are going to get- so stop, and with new washers you will seal better and may not bottom out.

You do not necessarily need to change plugs just because you are changing a worn / leaky VCG.

http://www.ecstuning.com/BMW-E46-330...s/Valve_Cover/
Reply With Quote
  #3  
Old 11-24-2012, 11:43 PM
GoForthFast GoForthFast is offline
Officially Welcomed to the 'Fest
Location: New York
 
Join Date: Jul 2004
Posts: 2,443
Mein Auto: '04 330Ci 6-speed
Spark plug hole gaskets come with the kit, so replace them all at the same time.
But they rarely leak.
Reply With Quote
  #4  
Old 11-25-2012, 08:17 AM
Scottji's Avatar
Scottji Scottji is offline
Officially Welcomed to the 'Fest
Location: California
 
Join Date: Feb 2011
Posts: 614
Mein Auto: 2004 325i
A telescoping inspection mirror, which should be mandatory for any garage, will assist you in diagnosing the VCG leak. Get the mirror and a flashlight, and check along the bottom edge of the exhaust side of the valve cover. But as QAfred said, the fact that you found oil on the metal flange strongly suggests VCG leak.
Reply With Quote
Reply

Bookmarks


Forum Navigation
Go Back   Bimmerfest - BMW Forums > BMW Model Discussions > 3 Series / 4 Series > E46 (1999 - 2006)
Today's Posts Search
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



Forum Jump


All times are GMT -7. The time now is 04:32 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
© 2001-2011 performanceIX, Inc. All Rights Reserved .: guidelines .:. privacy .:. terms