|
|
||||||
|
5 Series DIY
Knowledge Is Power! ~ The place for do-it-yourself threads on a variety of topics. Start a thread describing a particular job (oil change, cooling system overhaul, brakes, shocks and springs, etc.) or search for one you need help with! |
|
|
|
Thread Tools | Display Modes |
|
#1
12-19-2012, 03:07 PM
|
|||
|
|||
|
Crankshaft positioning sensor repl
LOOKING FOR SOME INSIGHT ON CHANGING MY CRANKSHAFT POSITIONING SENSOR ON MY 2008 528I - FROM THE DIAGRAM THAT I HAVE THIS PARTICULAR SENSOR IS LOCATED ON DRIVER SIDE LOWER PART OF ENGINE CLOSER TO BACK WALL. i AM WONDERING IF IT WOULD BE EASIER TO REACH FROM THE BOTTOM VS. THE TOP?
HAS ANYONE EVER REPL'D THIS PARTICULAR PART IN THIS VEHICLE - aNY HELP OR SUGGESTIONS WOULD BE VERY HELPFUL. - TRYING TO AVOID THE STEALERSHIP THANKS. 
|
|
#2
01-25-2013, 06:45 PM
|
|||
|
|||
|
It's right underneath the starter. It's a pain to get to from the top or the bottom.... it's held on by 1 hex bolt
|
|
|
| Bookmarks |
| Forum Navigation | |||||||
|
Today's Posts Search | ||||||
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
