Bimmerfest - BMW Forums - Search Results



Go Back   Bimmerfest - BMW Forums > Search Forums

Showing results 1 to 25 of 31
Search took 0.01 seconds.
Search: Posts Made By: ugeek
Forum: E63 / E64 6 Series (2004 - 2010) 08-15-2018, 05:26 PM
Replies: 14
Views: 3,218
Posted By ugeek
Similar issue...

How can you connect the valve cont module incorrectly? Only two connectors? And do you know if it was the aftermarket Ecc Sensor causing the problem? thanks
Forum: E60 / E61 (2004 - 2010) 07-27-2018, 02:57 PM
Replies: 504
Views: 382,888
Posted By ugeek
No, it means to reset using INPA...just have it...

No, it means to reset using INPA...just have it run through each program in each of the modules - I think there are 4 or 5 of them as I recall. I think the reset you are referring to is really a...
Forum: E60 / E61 (2004 - 2010) 07-27-2018, 12:10 PM
Replies: 504
Views: 382,888
Posted By ugeek
Did you make the changes needed for your special...

Did you make the changes needed for your special requirements (not the simple case) in the VO and save them.. Its been a while since I did this but i had a couple changes in VO that related to the...
Forum: E46 (1999 - 2006) 04-26-2018, 02:45 PM
Replies: 11
Views: 5,694
Posted By ugeek
On my 07 E60 BMW 530i, I have picked up P0011,...

On my 07 E60 BMW 530i, I have picked up P0011, P0012, P1554, P0014 and P0015 in various combinations. I had just replaced in past 5 mos. the battery, starter 2x, water pump 2x, and crank pos sensor...
Forum: E60 / E61 (2004 - 2010) 04-17-2018, 10:37 PM
Replies: 2
Views: 496
Posted By ugeek
resolution

Just so you all know, third time was the charm. The two sensors from Ebay were both junk. I had to go to the dealer. Parts on ebay started at $10...the dealer after my discount was $120. The...
Forum: E60 / E61 (2004 - 2010) 04-11-2018, 04:00 PM
Replies: 2
Views: 496
Posted By ugeek
Crank Position Sensor P0335

Diagnosed bad crank sensor. Symptoms were car stalling bringing in several codes including transmission default limp mode P700. I could stop the car, it would clear the codes and run again fine for...
Forum: E60 / E61 (2004 - 2010) 03-30-2018, 10:31 AM
Replies: 27
Views: 13,447
Posted By ugeek
Bixman, did you ever solve this issue? Did you...

Bixman, did you ever solve this issue? Did you replace the Eccentric Snsr again on bank 2?
Forum: E90/E91/E92/E93 (2006 - 2013) 03-13-2018, 10:09 AM
Replies: 13
Views: 10,517
Posted By ugeek
I think it is the Eccentric Sensor as it can be...

I think it is the Eccentric Sensor as it can be damaged when valve cover is remvoved OR the connection is bad. Start with the ez stuff and check the Eccentric Snsr wiring and then if necessary, pull...
Forum: 7 Series - E65 / E66 (2002 - 2008) 02-16-2018, 05:44 PM
Replies: 12
Views: 1,212
Posted By ugeek
Hey - did yiou find the ISM?

Hey - did yiou find the ISM?
Forum: E60 / E61 (2004 - 2010) 02-12-2018, 10:53 PM
Replies: 22
Views: 23,204
Posted By ugeek
Rebuild the valve body

replace solenoids, seals, etc and this will all go away. it will take a day or tow, and lotsa reading but not like replacing the tranny. good luck
Forum: E60 / E61 (2004 - 2010) 01-26-2018, 11:16 AM
Replies: 2
Views: 336
Posted By ugeek
2007 e60 530i tran fault engine stops

My symptoms
I reset the learned memory. Engine and transmission function fine for about 15 min then.
1. sitting at idle, engine stops -stalls (no history of stalling)
2. Red transmission code...
Forum: Tools and Miscellaneous 01-07-2018, 04:54 PM
Replies: 52
Views: 17,445
Posted By ugeek
still have one for sale by any chance?

still have one for sale by any chance?
Forum: 7 Series - E65 / E66 (2002 - 2008) 11-08-2017, 09:16 PM
Replies: 5
Views: 2,229
Posted By ugeek
can you give any details on what you had to...

can you give any details on what you had to remove to do your fishing??? email [email protected]
Forum: BMW Coding and Programming 10-31-2017, 11:31 AM
Replies: 917
Views: 208,858
Posted By ugeek
Hey...I am in North San Diego County and have a...

Hey...I am in North San Diego County and have a couple F02s I need coding help and repair. I wll pay....I has ISTA a enet set up...have run the diagnostic. found no power out of zgm to CIC /KOMBI...
Forum: Site Feedback / Questions / Suggestions 10-15-2017, 03:23 PM
Replies: 13
Views: 924
Posted By ugeek
Any updates on third party hosting? Sux to have...

Any updates on third party hosting? Sux to have all these notes that say to update and then find out you cant...lol. So mb we need to just delete the pictures that cannot be seen...
Whats best way...
Forum: 7 Series - F01 / F02 / F03 / F04 (2008 - 2015) 10-15-2017, 01:41 PM
Replies: 13
Views: 11,110
Posted By ugeek
Update please

Any update? Are u selling the car off? Parts?
Message me if you are....I have a flood vehicle I just starting on and will need parts...thanks
Forum: 7 Series - F01 / F02 / F03 / F04 (2008 - 2015) 08-14-2017, 10:11 PM
Replies: 1
Views: 301
Posted By ugeek
coding F02 flood recovery ISTA help

Ihave experience with INPA - now need to set up ISTA. Please help...PM me. thanks
Forum: BMW Coding and Programming 04-17-2017, 01:18 PM
Replies: 6
Views: 8,302
Posted By ugeek
Icom

Where do I find an ICOM to use ISTA-P? ICOM come in many styles. Also what emulator is required?? I am in the Jackson, MS area if anyone is in the area that can help with the coding would be...
Forum: E90/E91/E92/E93 (2006 - 2013) 07-24-2015, 02:38 PM
Replies: 28
Views: 125,620
Posted By ugeek
Wow, really.....

AWESOMENESS:bow: Impressive to find a broken wire in a harness of spaghetti...
Forum: E90/E91/E92/E93 (2006 - 2013) 07-24-2015, 02:32 PM
Replies: 28
Views: 125,620
Posted By ugeek
Lovely Liz, Transmission cooler failure is the...

Lovely Liz,
Transmission cooler failure is the reason you find coolant in the transmission or vise/versa. Coolant is generally higher pressure but if your radiator is low or sucks (literally, when...
Forum: E60 / E61 (2004 - 2010) 07-03-2015, 10:04 AM
Replies: 38
Views: 18,774
Posted By ugeek
I had all the symptoms...flare ups, hard shifts,...

I had all the symptoms...flare ups, hard shifts, the 2-1 downshift bump....did NOT replace any solenoids. Put a Sonnax kit in - split the Mecha valve body...cleaned with brake cleaner. Shifts...
Forum: E60 / E61 (2004 - 2010) 07-03-2015, 10:02 AM
Replies: 38
Views: 18,774
Posted By ugeek
Also be prepared to use more like 8 qts of fluid....

Also be prepared to use more like 8 qts of fluid. Left my open and draining over a couple nights so a lot came out of the converter and cooler.
Forum: E60 / E61 (2004 - 2010) 07-03-2015, 10:00 AM
Replies: 38
Views: 18,774
Posted By ugeek
I had all the symptoms...flare ups, hard shifts,...

I had all the symptoms...flare ups, hard shifts, the 2-1 downshift bump....did NOT replace any solenoids. Put a Sonnax kit in - split the Mecha valve body...cleaned with brake cleaner. Shifts...
Forum: 7 Series - E65 / E66 (2002 - 2008) 07-03-2015, 09:45 AM
Replies: 20
Views: 21,000
Posted By ugeek
so what happens if you overfill? Lots of...

so what happens if you overfill? Lots of documentation on what happens if you do not fill adequately...does anyone know about over filling?
Forum: E60 / E61 (2004 - 2010) 04-25-2015, 04:44 PM
Replies: 184
Views: 186,488
Posted By ugeek
Thank you Motronic...going with the kit and...

Thank you Motronic...going with the kit and Sonnax....but then Europeantransmission offers reman for $3k plus core/shipping. Going to check into that....anyone have any experience from them (in...
Showing results 1 to 25 of 31

Forum Jump

All times are GMT -7. The time now is 12:36 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
© 2001- VerticalScope Inc. All rights reserved.