Bimmerfest - BMW Forums - View Single Post - Active Steering Fault - i have tried various things to resolve
View Single Post
  #24  
Old 01-05-2020, 02:09 PM
HerbP HerbP is offline
Super Moderator
Location: Georgia
 
Join Date: Jul 2009
Posts: 7,915
Mein Auto: 05 645Ci, 14 750 M-Sport
FYI this is the procedure. I don't think INPA will do this, but possible. You will have what you need shortly, & we will sort this out. If you had a misfire, you would be getting some type of fault. This could be seen with an OBD2 meter very easily.

The service function Commissioning/Adjusting active steering must be run during or after the following work:

axle alignment/wheel alignment (see Note)

work on the steering column

after replacing or programming the active steering control unit (AL)

after replacing or programming the steering column switch (SZL): only E60/E61/63/64

after replacing the steering column switching centre (SZL): only E90/91

Note:

Adjustment of the active front steering must be carried out:
Before adjustment work on the front axle/steering
after all mechanical work on the steering system
after the battery has been disconnected or electrical plug connections on the steering column switch cluster have been disconnected
after replacement/programming or coding of the following components:
Steering column switch cluster
DSC control unit
Active front steering control unit
ARS control unit

Connect vehicle to BMW diagnosis system.
Select and carry out initial operation/adjustment for active front steering under Service functions.


Note:
Only perform axle alignment/wheel alignment if:

- The diagnosis of the active steering leads to no defect (fault entry) and there is a deviation in the position of the steering wheel

- The guided troubleshooting on fault entry 'active steering' concludes with the with defect 'Wheel alignment'

- Repair measures are carried out that make axle alignment/wheel alignment necessary (see corresponding repair instructions)



replacing or programming the Dynamic Stability Control (DSC)

after replacing the steering gear

The sequence for Commissioning/Adjustment in the service function is as follows:

- Default setting of the cumulative steering angle sensor exactly to zero for any axle alignment/wheel alignment. Choice of calling up (see Note)

- Reset the engine location angle (AL)

- Run a steering-angle sensor adjustment (E60/61/63/64: SZL, E90/91: DSC)

- Clear SZL fault code memory: only E60/61/63/64

- Clear DSC fault code memory

- Calibrate the engine location angle (AL)

- If ARS is included as an option, clear the value for steering angle (ARS): only E60/61/63/64

- Clear AL fault code memory

- Calibrate total steering angle offset (AL): only E60/61/63/64 from 09/2005 and E90/91 after replacement of the steering gear

Last edited by HerbP; 01-05-2020 at 02:17 PM.
Reply With Quote