BimmerFest BMW Forum banner

wheel compatiblility 5 series and 3 series

498 views 0 replies 1 participant last post by  PXBMW 
#1 ·
Thanks in advance for the advice,

I was wondering if anybody had experience mounting a 5 series wheel (e60) on a current gen 3 series. The specs on the 5 series wheel are 17 x 7.5, ET 43, CB 72.6 mm.

My current OEM setup is 18 x 8, ET 34, CB 72.6 mm.

I believe the ET, width, and CB will be fine for mounting. However, I am not quite sure about clearing the brakes with the standard package. Thanks.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top