Hi all, I have version e89x 1.07 and 5.0.6 of INPA when i look up what codes i have on my car i get the following error codes: 12 DME/DDE CDA7 64 18 EGS 578E 61 20 RDC 604F E0 60 KOMBI A3B3 60 63 MASK/CCC E1CD 60 72 FRM A8AD 64 & A8C3 64 when i try to clear the codes using the clear button i...

The driver side knee airbag deployed in my car. I want to replace the airbag. Do I need to replace the srs module?

Anyone know where I can get the knee airbag for the 128i?

Hi there, My brother and I are going to replace the blower motor and final unit resistor in his 2001 740i and just wanted to know what precautions to take with the passenger side airbag as that is my brothers only real and final concern. We will obviously disconnect the battery throughout, but...

I took the air bag ECU out of my E39, yr2000 , 528i . Nothing at all happened . NO surprise explosions , car runs fine and all functions work as they should . I took it out to send it away to have error messages and faults cleared ( error / fault 240 ) after the airbag light came on after the...

Car is a Mini R56, but I assume issue and answer should be similar for most recent BMW / Mini models. Faulty sensors or clean contacts? Which sensor? Car had water in floor area - left side. I removed both seats and dried out the interior with a heater over a few days. During the process I...

SYMPTOMS A few weeks ago, the Airbag Light started to turn ON and stay ON sometimes only. I realized that it is not constant and it happens only when I start the engine and the start is a bit "heavy". (Case 1) When I turn the key to start the engine and it starts right away, the Airbag light...

Good day all, I had my rear bumper as well as L/R mirrors removed and repainted at a local shop. When I picked up the car I drove off and noticed I had the errors; Driver and front passenger airbags faulty. I do not have a reset tool, and would like to know if there is a bypass vice getting...

Hi, my yr 2000 528i has lite up the SRS light. BMW have "scanned" for the fault and report that the module needs to be replaced ( $2.5k ) . The car has not been in an accident , so its not an accident code that is causing the SRS light to come on. The drivers seat motor did blow a fuse ( seat...

Hoping that someone can help with the recent air suspension issues that I have been having. Of course the vehicle is literally freshly out of warranty. I have never had any issues whatsoever previously. I recently noted when I came out into my garage to hop in the car that the driver side front...

Hi, I want to deactivate all the airbags in my Z4 E85. Is this possible via cable or by removing fuses? Thanks.

G’day all!! My airbag light on my 2006 e83 X3 keeps coming on and off! I’ve worked out that if I put the key in the 1st position and leave it it bounces on and clears itself in about 10-15 seconds, but if I just start the car it pretty well says on, may turn itself off once or twice! I’ve...

:confused: Hello All, I have a 2014 328I that had a moderate collision. I replaced both airbag curtains, driver buckle and belt and driver steering wheel airbag. Everything cleared but I keep getting a code from my Ethos 93097C Drivers airbag resistance too high. I swapped out the airbag...

Hi I have an issue with the airbag lamp on my car. I had some trouble with the heating mat in the front driver's seat and took the whole seat out of the car to get it fixed. Long story short, I had to unplug the wires from the seat while the battery was connected. I knew it would trigger the...

Hello All- Helite's Leather Airbag Jacket combines a mechanical airbag apparatus with traditional cafe styling. Tune in to see how it held up over my winter commute! https://www.youtube.com/watch?v=7LYQTQR0PpM -MKL

:banghead: I CANNOT catch the springs and need help -- Should I be able to use a COMMON STRAIGHT screwdriver?? or, MUST it be curved?? :dunno: I'm using straight tools right now, trying to catch anything in there that might be the spring retainer. Based on probing with straight tools...

Started my 2004 E60 the other day and it blew the BST (battery safety terminal) out of no where and motor shut down. Purchased the C310 code reader (amazing) and cleared all faults but A375. Communication error between TCU and airbag control module. Fiber optics seem to be good. turns out I have...

Hello. I updated all my ecus with WINKFP, and i got a airbag fault when i was done. Any one have a solution, that removes them? Reading from car: Error code Kind of error 00 ZGM OKAY No Error stored 01 SIM/SGM OKAY No Error stored 02 SZL OKAY No...

Hi I was trying to tap into my fuse box. So I was pulling fuses in and out. But now I have fault code saying: "Passenger Restraint System". Did I plug one of the fuses back into the wrong slot? Can someone help me?